jdeadman

iTrader: (41)

depending on your motor's timing But With my revTech set at 0 I did the following


**********************************************ESC Info*********************************************
Controller:CAR_ESC
hardware version:HW427_V1.0
software version:V3.0_110930STOCK

**********************************************Sett ing**********************************************
[Profile/Mode No.]
Mode 1

[Profile Name]
profile1_car1

[Running Mode]
Forward Only with Brake(*)(+) Forward/Reverse with Brake Forward/Reverse Direct

[Drag Brake Force]
0%(*) 5% 10%
15% 20% 25%(+)
30% 100% Custom

[Low Voltage Cut-Off]
Non-Protection(+) 2.6V/Cell 2.8V/Cell
3.0V/Cell(*) 3.2V/Cell 3.4V/Cell
Custom

["DDRS" Start Mode]
Level 1 Level 2 Level 3
Level 4 Level 5 Level 6
Level 7 Level 8 Level 9(*)(+)

[Maximum Brake Force]
12.5% 25% 37.5%
50%(*) 62.5% 75%
87.5% 100%(+)

[Maximum Reverse Force]
25%(*)(+) 50% 75%
100%

[Initial Brake Force]
=Drag Brake Force 0%(*)(+) 20%
40%

[Neutral Range]
6%(Narrow)(*)(+) 9%(Normal) 12%(Wide)

[Turbo Open Time]
3 deg/0.1sec 6 deg/0.1sec 12 deg/0.1sec
18 deg/0.1sec(*) 24 deg/0.1sec Fastest(+)

[Over-Heat Protection]
Enable(*)(+) Disable

[Boost Start RPM]
1000 rpm 2000 rpm 3000 rpm(+)
4000 rpm(*) 5000 rpm 6000 rpm
7000 rpm 8000 rpm 9000 rpm
10000 rpm 11000 rpm 12000 rpm
13000 rpm 14000 rpm 15000 rpm

[Turbo Open Delay]
Off 0.1 sec 0.2 sec(+)
0.3 sec(*) 0.4 sec 0.5 sec
0.6 sec 0.7 sec 0.8 sec