Originally Posted by
brettweir78
From what I have read in the past the lrp motor has a lot of timing built in. I would try using the insert with no dots to see if the problem persists.
Thanks but as stated in my post I am using the insert with the least amount of timing (4 dot) See below -
4 dots / -10 degree end bell /27.5 degree total
3 dots / -5 degree end bell / 32.5 degree in total
2 dots / 0 degree end bell / 37.5 degree in total
1 dot / +5 degree end bell / 42.5 degree total
0 dots / +10 degree end bell / 47.5 degree in total
This was posted by someone earlier in the thread.