Originally Posted by
jdearhart
I asked this same question over on the B44.1 thread but figured I might get a quicker response here.
I'm working on a dirt oval project that is B44/B44.1 based and was curious to know if the front and rear driveshafts from the BJ4 are the same lengths as the B44/B44.1? JConcepts has an aluminum set and I'm trying to shave all of the weight I can, especially rotating weight.
Some of the changes from the BJ to the B44 were going with CVA from CVD. Along with the different Slipper. I think with some work, you might get them to work, but not a direct replacement.