Originally Posted by
old_dude
I have a question for anybody:
This weekend a friend of mine's car took a big hit on the track. Afterwards the car would not run. The 1s was blinking the "low voltage code". I had loaded the v3 no_timing software in the esc earlier in the day so I hooked up the programmer box and it would not power connect to the esc. I then hooked the esc to a 2s battery and it worked but it was showing the mod software. I reloaded the no_timing and set the voltage protection to off as I had earlier in the day and everything was fine.
Just curious about the reset to mod. Has anyone experienced that before?
930 stock and mod works with the low voltage cut off at 1s but the zero timing the software is being done now .for the low voltage cut off.
yes i have seen it before when the lcd box shows the mod software instead of the zero timing as the lcd box will appear to show any one of the 3 modes at anytime after a reset .i will talk to michael about it later todaY .