Originally Posted by
revo61
What is everyones preferd method of holding the battery in? Tape or Battery strap? Do you use a battery tray with the strap or velcro?
Go for a tape or even velcro straps if you can find that fits/screw, battery bar is not good and if over tighten will tweak your chassis, also it will stop the flex, so battery bar is out..
Also, I filled the top deck to make it thinner for more flex, it worked well. otherwise the rubber rings route is good too with counter sunk washers.
You could maybe invest into 0 blocks from TC6 for your wishbones, I never tried these on TC5 but my guess is that it would be good to raise/lower roll.
Make sure you set your antiroll bars evenly R/L, there is some ways to do it properly.
That's about it for now.