R/C Tech Forums - View Single Post - Tamiya TB-Evolution III
View Single Post
Old 07-28-2004, 07:03 PM
  #6476  
WC
Tech Master
iTrader: (28)
 
WC's Avatar
 
Join Date: Jan 2002
Location: Global Citizen
Posts: 1,944
Trader Rating: 28 (100%+)
Default Re: Re: one way

Originally posted by hierog
how did you get the bearing to sit in the front plastic center piece? CA glue
Put the plastic bit so that the bearing goes in from the REAR.

Bearing then can't fly out forwards in a smack.


If the 1260 bearing is excessively floppy I shim it with a little bit
of masking tape on the outside until its a snug fit. About 5-10mm
(yellow Tamiya tape) is enough.
WC is offline