Originally Posted by
iwkyb
Hello all, new to the forum and also new to the brushless system
I am currently running a 13.5 MMM SP motor on a tekin RS pro for 1/10 TC. Was wondering what would be a good starting gear ratio for 13.5 boosted.
Also is it true that I should not run anymore than 64 degrees total of timing advance? and is the ballend timing on the MMM calibrated to the software timing? ie. if I am running 11 degrees on the motor - then I shouldn't run more than 53 degrees on software
thanks for the help
The speed control will only apply 64* of timing even if you have more than that programmed into your setup. You can also run motor timing on top of the 64* with caution, it will work, you are just riding a fine line of over timing the motor and causing too much heat.
EDIT: Sorry, I thought you were talking about the SP speedo, not Tekin. Tekin will allow you to run full boost and full turbo (75* total) but I am not sure that their settings are actual full degrees of timing. 64* is just a guideline that Tekin states, most people I know run more than that plus some motor timing.