Originally Posted by Robudda723

First time with a pan, Raced off-road on and off for a while but started with an 18r and a touring car to get started on-road a couple weeks back. Looking for a general setup for my new CRC Pan to run on Carpet. I will start off with the setup on the CRC site. However have no clue about rollout and esc settings. It is a smaller track 150ft straight small tight infield.

The car has the 88 tooth spur.
LRP SXX Comp ESC
Everyone here runs the rear foams cut to 57mm, so the store owner cut mine the same, and CA'd the side walls front and rear.
1s Battery
10.5 motor

I am not sure of a recommended rollout, and LRP ESC settings for this, any guidance would be awesome. One local racer recommended a 37 tooth pinion to start, but not sure if that is based on the 88 tooth spur or the old 96 (Not sure what came originally) tooth.

Thanks,
Rob