Originally Posted by
#iZzy
http://serpent.com/file.php?FileID=5306
after a lot of test days with marc this is a very good base for us.
Small differences i used:
2.25mm Chassis
Stabilizers 1.4mm all-around
oil xceed 500 all-around
bracket 3 in rear
you have to test if the ride springs are okay for your driving style, because a lot of people here tried them already but the car handling wasn't good in their opinion so the most of them went back to serpent springs or hpi springs. We have a lot fast guys here which using the serpent sprigns
thanks for the setup...so Marc is only running 2 degrees rear toe and a fairly low roll center. It seems you are running the standard axle hex's. I am guessing your rear track width at the contact patch is about 2mm narrower than the front based on the hinge pin blocks you and Marc are using.