Originally Posted by
Solara
No...any V3 or MMM can handle as high as 50* timing....so the 30* is not the reason causing it, but if the board is acting weird, that is different story. I will test that sensor and will warranty you a new one...
P.S>..come to think of it, send in the motor as well, I am sure it is the regular V3 hand out motor but defintiely is not the 1S version...are you sure it is a V3 1S version..? Cause that is not a hand out motor that I send to IIC.
I was mistaken it was a 1S that was purchased at Snowbirds '11. I bought it off a fellow racer when I needed a 17.5. I confused it for a IIC hand out that he and I were talking about.
I'll get a RMA setup through the SP website on this ring... It looks similar and I can see the timing is shifted 20Deg or so from the position of the sensors... The funny thing is, if I shift the phases one spot to the clockwise rotation (so A -> B, B->C, C->A) positions, the motor runs smooth as silk... only backwards