R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 9
1
2
3
Last »
Search: Posts Made By: FPMX772
Showing results 1 to 25 of 208
Search took 0.02 seconds.
Forum: Offroad Nitro Engine Forum
05-18-2020, 11:55 AM
Replies: 4,467
Views: 575,761
Posted By FPMX772

I have an old TL 21 B7 pro that I ran a gallon...

I have an old TL 21 B7 pro that I ran a gallon through then put her away for the last 10yrs. I recently pulled her out of storage as I just got back into nitro. The motor runs as good as I remember...
Forum: Electric Off-Road
03-31-2019, 09:16 AM
Replies: 11
Views: 1,281
Posted By FPMX772

99% of the time, its always the sensor wire that...

99% of the time, its always the sensor wire that goes bad. I have had similar issues even after replacing a bad sensor wire just to find out that the new sensor wire I put in went bad. Try...
Forum: Electric On-Road
02-02-2019, 06:57 PM
Replies: 680
Views: 202,562
Posted By FPMX772

makes sense, thanks for the input!

makes sense, thanks for the input!
Forum: Electric On-Road
02-01-2019, 04:06 PM
Replies: 680
Views: 202,562
Posted By FPMX772

Quick opinion question for y'all. I haven't...

Quick opinion question for y'all. I haven't raced onroad in about 12 years. Im looking to get back into it but don't know which way to go regarding the aluminum chassis or carbon. The tracks near...
Forum: Electric Off-Road
01-28-2019, 08:40 AM
Replies: 26
Views: 9,362
Posted By FPMX772

What ride height are you running? I have not...

What ride height are you running? I have not experienced that with this truck, I did a lot with the T5M. The only changes I have made to the truck is going to V1 grey front and V1 green rear...
Forum: Electric Off-Road
01-02-2019, 09:42 AM
Replies: 1,023
Views: 283,243
Posted By FPMX772

So im looking to get back into wheeling. Sold my...

So im looking to get back into wheeling. Sold my old 22-4 a few years back and now I wanna at to my races. Been looking at this car for a while now. Not sure if you guys have covered this but I...
Forum: Electric Off-Road
12-16-2018, 02:40 PM
Replies: 732
Views: 246,696
Posted By FPMX772

No, I don't think the truck need it, but if you...

No, I don't think the truck need it, but if you have them try it and see if it is better for u
Forum: Electric Off-Road
12-12-2018, 08:20 AM
Replies: 7
Views: 1,364
Posted By FPMX772

But be careful doing this. Too much timing and...

But be careful doing this. Too much timing and you will burn your motor up. Your best bet is to get a motor analyzer for about 100 bucks, then tune the timing using it. I usually run all my motors...
Forum: Electric Off-Road
11-25-2018, 11:26 PM
Replies: 2,872
Views: 1,761,680
Posted By FPMX772

There is a 20 min vid about the car on 22 empire...

There is a 20 min vid about the car on 22 empire on FB
Forum: Electric Off-Road
11-24-2018, 09:22 PM
Replies: 4
Views: 831
Posted By FPMX772

depends on what type of surface your running on. ...

depends on what type of surface your running on. I run highbite clay and run 37.5 oil up front 30 weight in the back, Kyosho red spring up front and V1 AE green rear spring. Also this truck handles...
Forum: Electric Off-Road
11-19-2018, 09:56 AM
Replies: 732
Views: 246,696
Posted By FPMX772

Which body are you currently using? Do you have...

Which body are you currently using? Do you have any vent holes cut out in it as well?
Forum: Electric Off-Road
11-18-2018, 08:33 PM
Replies: 732
Views: 246,696
Posted By FPMX772

I went +1* up on the C block and left the center...

I went +1* up on the C block and left the center pill on the D block.
Forum: Electric Off-Road
11-16-2018, 06:21 PM
Replies: 732
Views: 246,696
Posted By FPMX772

Going to 37.5 will take away some of the...

Going to 37.5 will take away some of the snappiness this truck has when turning. If all you run is this truck and your good with 35 weight oil up front then stay with it. I run buggy and ST so...
Forum: Electric Off-Road
11-16-2018, 06:17 PM
Replies: 732
Views: 246,696
Posted By FPMX772

No its 91637

No its 91637
Forum: Electric Off-Road
11-15-2018, 01:14 PM
Replies: 732
Views: 246,696
Posted By FPMX772

This truck is pretty good right out of the box. ...

This truck is pretty good right out of the box. Go up to 35-37.5 weight oil in the front and other the V1 grey or KYO red spring in the front help a lot too. Running a front sway bar helps a lot as...
Forum: Electric Off-Road
11-15-2018, 01:12 PM
Replies: 2
Views: 2,079
Posted By FPMX772

I have mixed feeling about this topic. This past...

I have mixed feeling about this topic. This past weekend I ran a race at out local indoor clay track where the inside temp was 54* and the track temp way 48*. I figured I would lighten the oil up...
Forum: Electric Off-Road
11-15-2018, 07:26 AM
Replies: 732
Views: 246,696
Posted By FPMX772

I wouldn't recommend running any drag brake if...

I wouldn't recommend running any drag brake if your running 17.5 class as this creates unwanted heat build up in the motor. Like the other guys said, check to make sure your not holding the throttle...
Forum: Electric Off-Road
11-07-2018, 09:40 AM
Replies: 732
Views: 246,696
Posted By FPMX772

Check your end point on your servo. You might...

Check your end point on your servo. You might have it set to high causing the servo to over stress which can lead to extra pressure on those two mounting screws. I had this same issue and I re set...
Forum: Electric Off-Road
11-07-2018, 07:19 AM
Replies: 732
Views: 246,696
Posted By FPMX772

Try taking apart your front end to see if...

Try taking apart your front end to see if anything is binding. A guy at my local track actually broke one of the screws that holds the bell crank down which caused him to lack in steering. Also...
Forum: Electric Off-Road
11-06-2018, 09:41 AM
Replies: 732
Views: 246,696
Posted By FPMX772

If you use smaller spacers (1mm) on the ball cup...

If you use smaller spacers (1mm) on the ball cup on the steering rack, this should decrease ackerman and therefore have more aggressive off throttle steering and be smoother on throttle. If you add...
Forum: Electric Off-Road
11-05-2018, 07:58 PM
Replies: 732
Views: 246,696
Posted By FPMX772

Try bumping up to 37.5 oil in the front, put the...

Try bumping up to 37.5 oil in the front, put the +1 steer plate on, run the V1 grey springs and put a 1mm spacer under the front inner ball stud. This should all help tame down the steering a bit.
Forum: Electric Off-Road
11-03-2018, 10:55 AM
Replies: 14
Views: 6,109
Posted By FPMX772

Having ran the T6.1 for about a month now, I can...

Having ran the T6.1 for about a month now, I can say it is way better that the T5M. I owned the T5M since it came out a few years ago and only did minor upgrades like Ti screws/turnbuckles and some...
Forum: Electric Off-Road
10-28-2018, 08:23 PM
Replies: 613
Views: 180,290
Posted By FPMX772

Just depends on the motor and how much timing. I...

Just depends on the motor and how much timing. I ran a 17.5 V3 Fantom in my SC6.1 geared at 75/25 and then I swapped to a 17.5 Schuur Speed V4 geared at 81/22. I know there are two different...
Forum: Electric Off-Road
10-28-2018, 12:55 PM
Replies: 613
Views: 180,290
Posted By FPMX772

Depends on what motor your running. Im running a...

Depends on what motor your running. Im running a Schuur Speed V4 13.5 and am using 81/22. On an 8min main, with a WTF fan blowing on the motor, she comes off around 120
Forum: Electric Off-Road
10-28-2018, 09:34 AM
Replies: 3,819
Views: 1,070,472
Posted By FPMX772

It sure does look cool tho

It sure does look cool tho
Showing results 1 to 25 of 208
 
Page 1 of 9
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.