R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
 
Page 1 of 20
1
2
3
11
Last »
Search: Posts Made By: geeunit1014
Showing results 1 to 25 of 500
Search took 0.10 seconds.
Forum: Team and Company Discussions
02-14-2024, 05:50 AM
Replies: 1,176
Views: 268,864
Posted By geeunit1014

The OE1 MK2 is essentially the same footprint as...

The OE1 MK2 is essentially the same footprint as the original OE1, but takes up less overall space since there is no external cap any more. It’s about 10g lighter as well which is a bonus.

The...
Forum: Electric On-Road
12-20-2023, 06:18 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

Officina sells rolls of tape, and also a pre cut...

Officina sells rolls of tape, and also a pre cut skin for the chassis
Forum: Electric On-Road
12-01-2023, 10:00 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

It would be a hole for a pin used in a fixture...

It would be a hole for a pin used in a fixture during manufacturing
Forum: Electric On-Road
11-16-2023, 08:41 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

No, you would have to strip it out to make it...

No, you would have to strip it out to make it loose. There is a lot of screw engagement in the plastic so it’s very tight all the time
Forum: Electric On-Road
11-15-2023, 11:14 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

R1

R1
Forum: Electric On-Road
11-14-2023, 12:24 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

You would need PSS, 1.6mm top decks, a 1.2 front...

You would need PSS, 1.6mm top decks, a 1.2 front sway bar and 2.7 springs to run the carpet setup I have been using. PSS and 1.6 top decks are fairly common parts for carpet setups in general.
...
Forum: Electric On-Road
10-19-2023, 09:36 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

Fortunately on the X4 platform the lower arms are...

Fortunately on the X4 platform the lower arms are not a commonly broken item, you really have to try hard to damage the lower arms. The hubs are the “weak” link on the corners, which are much cheaper...
Forum: Electric On-Road
10-03-2023, 11:56 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

With the limiter that is installed on the...

With the limiter that is installed on the bellcranks the steering arms cannot hit the shock, they are scooped out on the inside to clear it. You would have to remove the limiter for this to be an...
Forum: Team and Company Discussions
08-19-2023, 07:11 AM
Replies: 1,176
Views: 268,864
Posted By geeunit1014

Ive always updated the programmer by putting the...

Ive always updated the programmer by putting the firmware on the sd card, and then loading it while the box is connected to a car.
Forum: Electric On-Road
04-26-2023, 05:38 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

The spool is going to be faster 99.9% of the...

The spool is going to be faster 99.9% of the time. You have more forward drive/on power steering, better brakes, and less rotating weight, so most racers are going to use a spool. I have always...
Forum: Electric On-Road
04-06-2023, 08:26 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

For me the lower arms don’t have quite as much of...

For me the lower arms don’t have quite as much of an impact as the upper arms, but there is still some difference. For lower grip the medium arms will be more consistent and easier to drive. If there...
Forum: Electric On-Road
03-28-2023, 02:36 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

I’ve never split the arms F/R, but the soft arms...

I’ve never split the arms F/R, but the soft arms definitely make a little more overall grip, at the expense of some corner speed if the grip is high. They typically work best on asphalt, or very low...
Forum: Electric On-Road
03-24-2023, 10:19 AM
Replies: 9
Views: 934
Posted By geeunit1014

which arrowmax pinions? The plastic ones use a...

which arrowmax pinions? The plastic ones use a 2-56 set screw (0.050” wrench)
Forum: Team and Company Discussions
03-14-2023, 11:48 AM
Replies: 1,176
Views: 268,864
Posted By geeunit1014

Correct, you can load any software file from the...

Correct, you can load any software file from the sd card into the esc, even an “older” version.
v4.2 may have been suggested as it is the legal software for blinky racing. V5 was not submitted for...
Forum: Electric On-Road
02-19-2023, 04:28 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

Not really. I have a 180 baseline setup on the ...

Not really. I have a 180 baseline setup on the site for 180 :) The difference in carpet is big enough there should really be a thick pile or thin pile option on the setup sheet
Forum: Electric On-Road
02-12-2023, 05:32 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

This will also depend on the shimming of the hub...

This will also depend on the shimming of the hub as well. If there is say 3mm of uptravel with that ride height and downstop and 0.5mm shim under the hub, if there is 1mm under the hub instead there...
Forum: Electric On-Road
02-07-2023, 12:15 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

Most setups are using the PSS sleeves/pistons for...

Most setups are using the PSS sleeves/pistons for carpet. I also use the 1.6mm top decks. Beyond that is just general tuning things like springs/swaybars, etc.
Forum: Electric On-Road
01-06-2023, 07:05 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

If you think there is air coming from the bottom...

If you think there is air coming from the bottom seal, you can put a 0.1mm shim against the o ring on the bottom to put more pressure on the o ring and tighten the seal
Forum: Electric On-Road
01-04-2023, 12:08 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

The 23 is very popular everywhere, it seems most...

The 23 is very popular everywhere, it seems most of the Xray community is active on Facebook these days. I have had great results so far this season with the 23, and don’t forget the double world...
Forum: Electric On-Road
11-10-2022, 11:49 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

I think the shock package should be similar to...

I think the shock package should be similar to the 22 if nothing else is changing. I am running lighter than last year on carpet, however the gravity tire this year has a bit less grip which is...
Forum: Electric On-Road
11-04-2022, 06:05 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

I don’t know exactly, I use Sanwa personally. I...

I don’t know exactly, I use Sanwa personally. I know power hd do make a direct mount servo for the x4 so that would be a safe bet
Forum: Electric On-Road
11-03-2022, 06:44 AM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

Any low profile servo will work. Sanwa, MKS,...

Any low profile servo will work. Sanwa, MKS, power hd are popular choices.
Forum: Electric On-Road
10-21-2022, 12:15 PM
Replies: 2,383
Views: 593,912
Posted By geeunit1014

O rings degrade quickly over time, the metal...

O rings degrade quickly over time, the metal clips will last longer. The new hexes also have the advantage of being completely flat so no more clip interference on the setup station.

The diff is...
Forum: Team and Company Discussions
10-17-2022, 08:35 AM
Replies: 1,176
Views: 268,864
Posted By geeunit1014

I never tried the blinky pro, but I did test the...

I never tried the blinky pro, but I did test the oe101 and never had any issues with it. The 101 is a step in between the BP and the OE1. I never found any real on track laptime difference between...
Forum: Team and Company Discussions
10-17-2022, 07:17 AM
Replies: 1,417
Views: 396,633
Posted By geeunit1014

They must be, just about everyone with a slot...

They must be, just about everyone with a slot machine ran a red rotor at the roar paved nats this weekend
Showing results 1 to 25 of 500
 
Page 1 of 20
1
2
3
11
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.