R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: pascalfd
Showing results 1 to 11 of 11
Search took 0.01 seconds.
Forum: Electric Off-Road
09-14-2014, 08:26 AM
Replies: 3,631
Views: 949,769
Posted By pascalfd

(this was response to previous post..) : +1 -...

(this was response to previous post..) : +1 - even a little longer wires for me and the sensor wire loosely zip tied to the other motor wires. I just don't want any wire flapping around in the car.
...
Forum: Electric Off-Road
09-14-2014, 07:55 AM
Replies: 3,631
Views: 949,769
Posted By pascalfd

Not sure about that wiring configuration - what...

Not sure about that wiring configuration - what makes you say it's the best ?

I would be concerned about the durability of this setup where the wires can constantly pull up/down on the motor and...
Forum: Electric Off-Road
06-22-2014, 08:02 AM
Replies: 3,631
Views: 949,769
Posted By pascalfd

Body looks great, but how do you get it to fit on...

Body looks great, but how do you get it to fit on the E car ? I have one of these bodies (for the Nitro MP9), but can tell it wouldn't fit on the MP9E as the rear curves down too much to clear ESC...
Forum: Electric Off-Road
02-13-2014, 03:02 PM
Replies: 3,631
Views: 949,769
Posted By pascalfd

When upper and lower arms are not connected they...

When upper and lower arms are not connected they will most likely always both move freely.
But good point also that you may have upper and lower inside pins not set up to be parallel and check you...
Forum: Electric Off-Road
02-13-2014, 01:14 PM
Replies: 3,631
Views: 949,769
Posted By pascalfd

Did you put any spacers already on the inside pin...

Did you put any spacers already on the inside pin of the upper arm ? It's possible you have too may front or back causing the binding.
Assemble the front completely without the spacer. Move up/down...
Forum: Electric Off-Road
02-07-2014, 09:17 PM
Replies: 3,631
Views: 949,769
Posted By pascalfd

MP9e TKI readyset

Browsing through the online 2014 RC Kyosho catalog - check page 49. (http://saas3.startialab.com/acti_books/1045173943/11544/_SWF_Window.html).

More pictures also on the kyosho orion facebook page
Forum: Electric Off-Road
08-10-2013, 08:50 PM
Replies: 3,631
Views: 949,769
Posted By pascalfd

What tread width are you running in the rear ?...

What tread width are you running in the rear ? Tebo's setup is a narrow setup (see rear tread section of the setup sheet). Check your bushing at the outside end of the rear arms.
FYI, I run medium...
Forum: Electric Off-Road
08-05-2013, 08:35 PM
Replies: 3,631
Views: 949,769
Posted By pascalfd

Simply use gravity to your advantage : place the...

Simply use gravity to your advantage : place the nuts in the mount and assemble while keeping the car nose down.
Forum: Electric Off-Road
08-04-2013, 11:35 AM
Replies: 3,631
Views: 949,769
Posted By pascalfd

How long are your quals and mains ? My take is...

How long are your quals and mains ? My take is that there is no point carrying around extra weight if not needed. For 12min mains (RX8 - T8 1900kv - 15T pinion) I run 5000mah batt and have no issue...
Forum: Electric Off-Road
04-16-2012, 06:49 PM
Replies: 3,631
Views: 949,769
Posted By pascalfd

This one : Turnigy nano-tech 45-90C...

This one : Turnigy nano-tech 45-90C (http://www.hobbyking.com/hobbyking/store/__17660__Turnigy_nano_tech_4500mah_4S_45_90C_Lipo_Pack.html)

Note : pack is quite long (yet low - so no body clearance...
Forum: Electric Off-Road
04-16-2012, 05:15 PM
Replies: 3,631
Views: 949,769
Posted By pascalfd

I used to run a 4000mah and could do 10min, but...

I used to run a 4000mah and could do 10min, but it didn't last long as I think it was discharged quite a lot much too often compared to a larger capacity pack. Now running a 4500 and so far so good.
Showing results 1 to 11 of 11


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.