R/C Tech Forums - Search Results

Search: Posts Made By: axnjaxn

Showing results 1 to 4 of 4
Search took 0.00 seconds.

Forum: Electric Off-Road

12-04-2011, 08:08 PM

Replies: 1,043

Castle Sidewinder SCT Thread

Views: 226,539

Posted By axnjaxn

Rdforme you called it- loose slipper, motor seems...

Rdforme you called it- loose slipper, motor seems to be fine. It was getting hot probably because it was geared too high. Its the older 4600kv and castle recommends no more than 15/87 for SC10 and I...

Forum: Electric Off-Road

12-02-2011, 11:35 PM

Replies: 1,043

Castle Sidewinder SCT Thread

Views: 226,539

Posted By axnjaxn

CM36s 4600kv castle motor overheated?

I think I cooked the motor, can a castle motor be rebuilt with new bearings etc or is it trash? Tried taking it apart but the end caps seem to be glued in, screws out and caps don't budge..

It was...

Forum: Electric Off-Road

01-17-2011, 08:09 AM

Replies: 1,043

Castle Sidewinder SCT Thread

Views: 226,539

Posted By axnjaxn

I found a couple longer screws, about 8mm of...

I found a couple longer screws, about 8mm of thread. Installed with included washer and added another .5mm washer. Snugged it up with some blue loctite, making sure not to over torque and we will see...

Forum: Electric Off-Road

01-16-2011, 03:56 PM

Replies: 1,043

Castle Sidewinder SCT Thread

Views: 226,539

Posted By axnjaxn

+1 here Included screws only capture about half...

+1 here
Included screws only capture about half of the available threads in the motor when mounting to a stock sc10 motor plate. Screws are too short. There is room for them to be 1 or 2 mm longer....

Showing results 1 to 4 of 4