R/C Tech Forums - Search Results

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Community
Wiki Posts
Search
Search: Posts Made By: Randy_Pike
Showing results 1 to 4 of 4
Search took 0.01 seconds.
01-14-2013, 12:04 PM
Replies: 21
Views: 3,033
Posted By Randy_Pike

First you MUST not run the esc without a...

First you MUST not run the esc without a capacitor, it's listed in the directions.

At this point it looks like you've damaged some fets and the unit will require repair/replacement.

That info...
01-14-2013, 12:03 PM
Replies: 21
Views: 3,033
Posted By Randy_Pike

Negative! You only need to re calibrate your...

Negative! You only need to re calibrate your radio after upgrading software. You do NOT have to radio calibrate after making adjustments.
01-04-2013, 10:55 AM
Replies: 21
Views: 3,033
Posted By Randy_Pike

Once the update is done, perform a factor reset...

Once the update is done, perform a factor reset on the unit by powering it up, hold down both buttons for 5 seconds, let it perform it's light and chime sequence. Then perform a radio calibration....
01-04-2013, 10:18 AM
Replies: 21
Views: 3,033
Posted By Randy_Pike

Sounds like the updated may have been...

Sounds like the updated may have been interrupted. Re update the esc's software, re test.
Showing results 1 to 4 of 4


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.