R/C Tech Forums - Search Results

Search: Posts Made By: BuggyKing

Showing results 1 to 9 of 9
Search took 0.01 seconds.

Forum: Electric Off-Road

04-04-2010, 12:00 AM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

the best thing to do is if it heats up fast gear...

the best thing to do is if it heats up fast gear down and if it runs cold gear up is my way of gearing motors etc.

Forum: Electric Off-Road

04-03-2010, 11:54 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

Maybe try a 20 tooth pinion.

Maybe try a 20 tooth pinion.

Forum: Electric Off-Road

04-03-2010, 11:08 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

I dont remember what turn that motor is off...

I dont remember what turn that motor is off hand.:confused::confused:

Forum: Electric Off-Road

04-03-2010, 10:40 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

The stock spur if I remember correctly is a 94...

The stock spur if I remember correctly is a 94 tooth.

Forum: Electric Off-Road

04-03-2010, 10:29 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

yes new slipper pads should do the trick. Good...

yes new slipper pads should do the trick. Good Luck.

Forum: Electric Off-Road

04-03-2010, 10:22 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

Do you have the proper slipper wrench you need to...

Do you have the proper slipper wrench you need to adjust the slipper nut.:confused:

Forum: Electric Off-Road

04-03-2010, 10:04 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

What I tryed and worked to is run a longer screw...

What I tryed and worked to is run a longer screw through the tensioner and use a locking nut on the backside. This will keep the tensioner from getting loose.

The belt should have a small amount...

Forum: Electric Off-Road

04-03-2010, 09:58 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

I would go with a new belt pullies, tensions...

I would go with a new belt pullies, tensions bearings. Thata probably only parts you should need. Also look into the aluminum hinge pin mounts. The plastic ones won't hold up all that well.;)
...

Forum: Electric Off-Road

04-03-2010, 09:50 PM

Replies: 22

XXX-4 slipper rebuild.

Views: 4,316

Posted By BuggyKing

go ahead and rebuild and on the screw that holds...

go ahead and rebuild and on the screw that holds the belt tensioner use threadlock. That seemed to work well for me. Just after your done running ur buggy recheck it cause it will get loose.

Showing results 1 to 9 of 9