R/C Tech Forums - Search Results
R/C Tech Forums

Go Back  R/C Tech Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Wiki Posts
Calendar
Today's Posts
Search
Vendor Directory
Search: Posts Made By: exage94
Showing results 1 to 25 of 25
Search took 0.01 seconds.
Forum: Electric Off-Road
11-23-2017, 12:20 AM
Replies: 720
Views: 232,405
Posted By exage94

Already out of stock :( . Does anybode else found...

Already out of stock :( . Does anybode else found a other good offer for the KC2?
Forum: Electric Off-Road
09-05-2017, 06:26 AM
Replies: 5,186
Views: 1,252,026
Posted By exage94

Hello, Which YZ2 version would be better for...

Hello,
Which YZ2 version would be better for astro turf and carpet, the CA or DTM edition? Obviously the CA edition is especially for carpet, but the DTM is maybe more improved?
Where are the...
Forum: Electric Off-Road
09-05-2017, 06:23 AM
Replies: 1,785
Views: 430,897
Posted By exage94

Any updates when the YZ4s will be released?

Any updates when the YZ4s will be released?
Forum: Nitro Off-Road
07-07-2016, 03:25 PM
Replies: 4,347
Views: 1,157,400
Posted By exage94

Someboy switched from mugen,kyosho or tlr to the...

Someboy switched from mugen,kyosho or tlr to the xb8 16 and can compare it ?
Forum: Nitro Off-Road
06-27-2016, 02:26 PM
Replies: 3,086
Views: 991,164
Posted By exage94

Hey guys, i have Seen in a lot of Sheets, that...

Hey guys,
i have Seen in a lot of Sheets, that they are running the tki3 suspention holder and knuckles.

Whats the point for that ?

Kind regards
Forum: Radio and Electronics
06-08-2016, 05:41 AM
Replies: 1
Views: 709
Posted By exage94

Which ESC for 1/10th 4wd buggy racing

Hey @ all,

i am new to 1/10, normally i run an 1/8 buggy.
I want to take part at lots of races, so i want a good/ the best ESC for an 4wd buggy. Here in Germany, we run a lot on carpet and astro....
Forum: Electric Off-Road
05-31-2016, 11:24 AM
Replies: 13,618
Views: 2,599,947
Posted By exage94

Whats a good pinion to start for a 10.5 Motor? ...

Whats a good pinion to start for a 10.5 Motor?
Stock 81t Main gear.
Forum: Electric Off-Road
04-18-2016, 07:29 AM
Replies: 2,107
Views: 686,091
Posted By exage94

Hey guys , can anyone tell me the length for...

Hey guys ,

can anyone tell me the length for the front and rear hing pins ? I dont finde a information...

THX
Forum: Nitro Off-Road
04-18-2016, 05:09 AM
Replies: 1,534
Views: 430,796
Posted By exage94

Hey guys, Which partnumber has the mugen...

Hey guys,

Which partnumber has the mugen hing Pins for the 4.0?
They are diffrents at mugen for the Front and Rear...

Thx
Forum: Electric Off-Road
04-17-2016, 04:26 PM
Replies: 1,286
Views: 399,473
Posted By exage94

Hey guys, Which partnumber has the mugen...

Hey guys,

Which partnumber has the mugen hing Pins for the 4.0?
They are diffrents at mugen for the Front and Rear...

Thx
Forum: Electric Off-Road
04-14-2016, 02:28 PM
Replies: 1,286
Views: 399,473
Posted By exage94

Does anyone know if a sway bar from another Brand...

Does anyone know if a sway bar from another Brand will fit in the Front?
Forum: Nitro Off-Road
03-30-2016, 01:13 AM
Replies: 4,347
Views: 1,157,400
Posted By exage94

I hope they release an electric version not to...

I hope they release an electric version not to late ....
Forum: Nitro Off-Road
03-29-2016, 01:14 AM
Replies: 1,534
Views: 430,796
Posted By exage94

Setup Question

Hey,
what will change,if i put the spindle high from low (kit setup) to the high position?
And whats with the short akermann?
I run on an very high bite astro track..
Forum: Electric Off-Road
03-27-2016, 09:36 AM
Replies: 1,286
Views: 399,473
Posted By exage94

Setup Question

Hey,
what will change,if i put the spindle high from low (kit setup) to the high position?
And whats with the short akermann?
I run on an very high bite astro track..
Forum: Electric Off-Road
03-14-2016, 05:16 AM
Replies: 1,286
Views: 399,473
Posted By exage94

Smile Astroturf

Hey Guys,

had anyone run this or the 3.0 on astroturf?
In 2 weeks the season will start here in germany and a good starting setup for a very high traction astro turf track would be awesome!...
Forum: Radio and Electronics
03-03-2016, 07:42 AM
Replies: 0
Views: 325
Posted By exage94

Your choice for an 1/8th ebuggy BL-comp

Hey guys,

i have planed to purchase a new combo for 1/8 ebuggy and dont know which comp it will be.
My old esc was an Tekin Rx8 gen2 with an Hacker Skalar 1900kv motor.
Everything was fine with...
Forum: Electric Off-Road
02-25-2016, 02:06 AM
Replies: 65
Views: 21,119
Posted By exage94

Which is your favorite and why? I am looking...

Which is your favorite and why?
I am looking for a new buggy, but here in Europe/Germany we have lots of high grip astro tracks and 90% drive a mugen and i dont like it when everyone hase the...
Forum: Electric Off-Road
10-28-2015, 08:50 AM
Replies: 1,798
Views: 527,471
Posted By exage94

The official setup sheets for the rc8b3e are a...

The official setup sheets for the rc8b3e are a little bit confusing.
Why the pros dont use the gasket for their diffs?
Forum: Radio and Electronics
10-12-2015, 04:24 PM
Replies: 3,885
Views: 647,647
Posted By exage94

Hey Guys, I have a Problem with my tekin rx8...

Hey Guys,
I have a Problem with my tekin rx8 gen2. If i use sensor cable to connect my esc with my motor, the esc dont start.
I tryed different Cables and motors, the Problem is always there....
Forum: Nitro Off-Road
08-05-2015, 07:37 AM
Replies: 4,257
Views: 1,302,218
Posted By exage94

Had anyone Problems with the front lower Arms...

Had anyone Problems with the front lower Arms during the build?
I found it a bit difficult to get them free working for the hingpins.
Forum: Nitro Off-Road
08-03-2015, 06:57 AM
Replies: 4,257
Views: 1,302,218
Posted By exage94

Hey guys, Whats wrong with my kit ? Yesterday...

Hey guys,
Whats wrong with my kit ?
Yesterday was the first time on the track with my new rc8b3 and i broke 3 parts without any hard Crash.
1. After an half round the plastic at the end of the...
Forum: Nitro Off-Road
07-28-2015, 02:34 PM
Replies: 4,257
Views: 1,302,218
Posted By exage94

Hey guys , i am a little bit confused about the...

Hey guys , i am a little bit confused about the shock pistions .
I have always run 1,3 x 8 .
1. Where are the differences in flat and tapered pistions?
2.Which other 1,3 x 8 pistions fit for the...
Forum: Nitro Off-Road
07-23-2015, 05:39 AM
Replies: 4,257
Views: 1,302,218
Posted By exage94

Hey guys, How many shims do you put under the...

Hey guys,
How many shims do you put under the planet and sun gears in the diffs?
Forum: Nitro Off-Road
07-22-2015, 11:41 AM
Replies: 4,257
Views: 1,302,218
Posted By exage94

Which shock pistions Do you prefer?

Which shock pistions Do you prefer?
Forum: Nitro Off-Road
07-07-2015, 12:38 PM
Replies: 37
Views: 10,943
Posted By exage94

Hey , where are the main differents in die 3...

Hey , where are the main differents in die 3 Designs ?(Pivotball(kyosho)/long arm(kyosho)/knuckle (agama)

This season, i switched from Kyosho to Mugen , because the german Distributor for Kyosho...
Showing results 1 to 25 of 25


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.