Reedy vs Tekin motor
#1
Tech Apprentice
Thread Starter
Reedy vs Tekin motor
I have a Losi 2wd SCT with a Tekin RS ESC and also a TEN-SCTE 4x4 with a Tekin RX-8 ESC. For various reasons, I have to change out the two Tekin motors. One racer suggested using the top of the line Reedy motors, such as the Sonic 550 4.5 turn in the 4x4.
My questions are:
1. Is Reedy equivalent to Tekin?
2. Manufacturer support?
3. Would a Reedy work properly with a Tekin ESC?
4. Will my Tekin Hot Wire work properly with the Reedy?
5. Does it hurt possible sale with mixed motor and ESC?
I don't remember the Tekin ESC "asking" what type of motor it's running or does it even care. What's your opinion?
TakeAim
My questions are:
1. Is Reedy equivalent to Tekin?
2. Manufacturer support?
3. Would a Reedy work properly with a Tekin ESC?
4. Will my Tekin Hot Wire work properly with the Reedy?
5. Does it hurt possible sale with mixed motor and ESC?
I don't remember the Tekin ESC "asking" what type of motor it's running or does it even care. What's your opinion?
TakeAim
#2
Tech Master
iTrader: (97)
1) Reedy motors are smoother than the Tekin...
2) i know i have called Tekin and had no problems, i don't know about Reedy, but LRP is awesome
3) Reedy would work fine with a Tekin Esc
4) i don't understand...hotwire is only used on Tekin ESC
5) it doesn't hurt to run mis matched motors/esc but i like to stay the same
btw...4.5turn motor is EXTREMELY over powered in a 2wd sc...esp a 550 can.
i don't know your driving skills, but i'd stay anywhere bt 10.5-17.5 540 can
2) i know i have called Tekin and had no problems, i don't know about Reedy, but LRP is awesome
3) Reedy would work fine with a Tekin Esc
4) i don't understand...hotwire is only used on Tekin ESC
5) it doesn't hurt to run mis matched motors/esc but i like to stay the same
btw...4.5turn motor is EXTREMELY over powered in a 2wd sc...esp a 550 can.
i don't know your driving skills, but i'd stay anywhere bt 10.5-17.5 540 can
Last edited by Tran901; 07-25-2012 at 10:15 PM.
#3
Tech Elite
iTrader: (36)
I have a Losi 2wd SCT with a Tekin RS ESC and also a TEN-SCTE 4x4 with a Tekin RX-8 ESC. For various reasons, I have to change out the two Tekin motors. One racer suggested using the top of the line Reedy motors, such as the Sonic 550 4.5 turn in the 4x4.
My questions are:
1. Is Reedy equivalent to Tekin?
2. Manufacturer support?
3. Would a Reedy work properly with a Tekin ESC?
4. Will my Tekin Hot Wire work properly with the Reedy?
5. Does it hurt possible sale with mixed motor and ESC?
I don't remember the Tekin ESC "asking" what type of motor it's running or does it even care. What's your opinion?
TakeAim
My questions are:
1. Is Reedy equivalent to Tekin?
2. Manufacturer support?
3. Would a Reedy work properly with a Tekin ESC?
4. Will my Tekin Hot Wire work properly with the Reedy?
5. Does it hurt possible sale with mixed motor and ESC?
I don't remember the Tekin ESC "asking" what type of motor it's running or does it even care. What's your opinion?
TakeAim
2. You shouldnt have any problems with tech support.
3. Any motor will work fine with a Tekin ESC. Sensored or sensorless. Just make sure you set up the ESC as such.
4. No. Hotwire is for Tekin products only.
5. I would not see any resale problems just cuase it has a Tekin ESC and Reedy motor. Worst case sonerio, you sell them seperate.
As far as the speedo asking, when you are linked with the Hotwire, you can choose between sensored, sensorless or dual mode. Turbo only works in dual mode but I may be wrong.
And for the 4x4 SC, I would get the 5.5. I ran both a 4.5 and 5.5 and didnt notice any performance gain in the 4.5. But I gained about 1.5-2 minutes of run time in the 5.5. Same track, setup, and speedo settings all on the same day.
#4
Hotwire has nothing to do with the motor. It's for programming the speedo, the motor doesn't matter.
Reedy and LRP are NOT the same company. They are just both dist by AE in the US.
Reedy and LRP are NOT the same company. They are just both dist by AE in the US.