My boat project
#1
Super Moderator
Thread Starter
My boat project
I've had one boat a really long time ago, I picked up a used Hammer boat for $50 shipped, it looks pretty well, but I have some left over slash electronics that I have no use for, that I was going to stick in it. The motor in the boat is supose to be bad.
Last edited by roadrashracing2; 10-15-2009 at 10:10 PM.
#2
Super Moderator
Thread Starter
well started taring it down and this thing must have been ran in salt water, lots of rust. The motors junk, the speed control works but could get replaced. I am not trying to spend a lot just to get something to play with in the local pond.
#3
Tech Rookie
need to get some videos up of it running when you get it done...should be interesting with slash electronics
#4
Guest
my boat project
Oh, ok.
Last edited by DLM; 11-08-2009 at 08:20 PM. Reason: Boat was sold
#5
Super Moderator
Thread Starter
boat was sold a few weeks ago, it was a nugget in the water
#7
Tech Adept
you can install the slash stuff but you have to replace the speed controller too
#8
Super Moderator
Thread Starter
it had a slash speedcontrol and motor, but it was still not fun.