nbrancalhaojr

I have a problem with two of my four receivers.
I can't bind both with my M11X, the leds blinks weird.
The receivers were used in my Mugen MBX offroad.
I have another two that work fine, so I think the TX is ok
You can see how it goes here:

+ YouTube Video

bambambennett

Try to hold bind button, then apply power to RX, wait 3 seconds with button depressed, then release and hit enter on your radio. The manual states to do it this way.

nbrancalhaojr

Yes, I've made this like manual says, no sucess.

banana rt

i think its time to replace it man. its failure systems. and im sure its not easy to bring it back to life, have u contact the customer support airtronics? many says theyve a good service

Slo_E4

iTrader: (62)

Are you sure? That's not how you did it in the video...

tajar66

iTrader: (6)

Do you have the proper type of receiver selected on the TX?? With my MT4 I have to select for fhss2 fhss3 ect.......

nbrancalhaojr

Off the video.....and the result is the same.

nbrancalhaojr

Always selected like FHSS3, thanks.

Slo_E4

iTrader: (62)

Pop it open and have a look inside, see if anything looks suspicious on the board...