durtbag

Not on the list...... but just had to have one.
Looking for set up help for 13.5 Blinky?
Terry

durtbag

Dbl post?

COBRARACING

http://roarracing.org/4rmb/showthrea...ck-30401020037

Motors listed you can find more winds on the same forum

Monsta

iTrader: (4)

Where do you find v3 508?
I have a v3.1 and the only software versions i can see are 129_beta, 526_beta and 918_beta.
USB software is v3.4, LCD is V1.11_120331_V3

Im using a reedy 13.5 in blinky and have little braking power.

COBRARACING

Sorry v3 508 is for the 2.1v .please drop all the turbo and timing and the red led will blink on the v3.1 which is zero timing state.

Monsta

iTrader: (4)

I have it blinky mode thanks, my issue is lack of braking power. I was running a v3 in 17.5 boosted (reedy as well) which had great brakes, but since upgrading to the v3.1 for 13.5 the brakes are very weak.

Is there another software version like v3_508 i should use to improve it?
These are my settings;
Forward Only with Brake
Drag Brake - 0%
Brake Strength - 100%
Initial Brake - =Drag Brake


Thank you

FunkyDunky

Hi guys I need help :-s

Been using my v3 in my off-road buggy in mod settings with no problems, I moved the ESC into a touring car on a 13.5 and updated the esc with the latest firmware, changed the software settings to 13.5 and now my on/off button doesn't work? I've upgraded the software on the ESC a few extra times to make sure it wasn't that and double checked all cables and settings etc that I can find. I'm not a newby but Is there something I'm missing or does it now have a fault?


Cheers

markrobinson

The button won't work without the tx being turned on

Monsta

iTrader: (4)

Any ideas/help?

Kbmoss

iTrader: (14)

Try full reverse?

Sean B.

iTrader: (13)

Hello,
New to the V3.1.
Are there any good setups for blinky 17.5 TC on carpet?
Thanks!

madjack

iTrader: (28)

Big thanks to the HW customer service crew - after the firmware updates, the ESC is a bullet off the corners.

idbdoug

iTrader: (41)

Drop PUNCH RATE SWITCH POINT down to 1, default is 50. Make sure 1st and 2nd STAGE PUNCH RATE is set at 30, highest value. Dropping the PUNCH RATE SWITCH POINT down this low will give u everything the motor can give you earlier than the stock setting of 50.
idbdoug

COBRARACING

Your low braking can be caused by your motor as well.

Please send me an email to [email protected]

hobby jolly

Do you test it?how do you think it?