Bad Lipo or Need BEC or ESC?
#1
Bad Lipo or Need BEC or ESC?
Alright, I just bought a Castle Sidewinder SV2 1406-4600kv
heres my setup
Blitz ESE
MKS DS1210 Servo
Gearing 18/88
JR XS3 FM Radio
Deans Connectors
I put a Turnigy nano-tech 5300 50c in and under full throttle it cuts out, under partial throttle it moves fine.. Lil cogging
Since I just bought this JR radio, I switched the receiver for another one and switched the lipo for a 5300 30c. It ran fine and only had some cut outs when it was getting low in voltage
When you turn on the ESC it beeps l3 times then goes ready, normal?
I think its either a BEC issue or the 50c lipo is bad?
Thanks
heres my setup
Blitz ESE
MKS DS1210 Servo
Gearing 18/88
JR XS3 FM Radio
Deans Connectors
I put a Turnigy nano-tech 5300 50c in and under full throttle it cuts out, under partial throttle it moves fine.. Lil cogging
Since I just bought this JR radio, I switched the receiver for another one and switched the lipo for a 5300 30c. It ran fine and only had some cut outs when it was getting low in voltage
When you turn on the ESC it beeps l3 times then goes ready, normal?
I think its either a BEC issue or the 50c lipo is bad?
Thanks