Mamba Max Pro calibration not working
#1
Mamba Max Pro calibration not working
Hi,
Just setting up my Mamba Max Pro and Airtronics MT-4....
I have succesfully binded the radio and receiver...the servo turns (I had to reverse the direction in the menu on the MT-4) but I cannot calibrate the mamba max pro for the life of me...
Basically I turn the radio on, full throttle like they say, turn the mamba max pro on and then this happens:
green LED pulses...the esc makes the dlll dlll dlll dll noise....red LED pulses about 12 times....all LED's pulse 4 times with the dll dll dll dll noise...yellow pulses forever...
If I take the throttle off, all LED's pulse twice and then the yellow pulses twice then a break...twice then a break...twice then a break...forever...
HELP!
Thanks!
Just setting up my Mamba Max Pro and Airtronics MT-4....
I have succesfully binded the radio and receiver...the servo turns (I had to reverse the direction in the menu on the MT-4) but I cannot calibrate the mamba max pro for the life of me...
Basically I turn the radio on, full throttle like they say, turn the mamba max pro on and then this happens:
green LED pulses...the esc makes the dlll dlll dlll dll noise....red LED pulses about 12 times....all LED's pulse 4 times with the dll dll dll dll noise...yellow pulses forever...
If I take the throttle off, all LED's pulse twice and then the yellow pulses twice then a break...twice then a break...twice then a break...forever...
HELP!
Thanks!
#3
Ok...I guess I had a brainfart moment but something is still strange...
The guide says the motor will make the beeps but the controller actually does it...
So I think I got it calibrated but when I ran it the throttle and brake were reversed?!
When I go full throttle, the esc is solid red....full brake/reverse, the esc is solid green...neutral it flashes yellow...
This is strange?! I had to reverse the servo direction in the airtronics but when I do that after calibration the motor will not turn...
How do I find the software version?
Thanks!
Last edited by lip; 06-07-2011 at 10:36 PM.
#5
duuuhhh....wow sometimes it pays for doing work before midnight!!!
I can't believe I didn't switch the motor leads...I don't have the software hookup kit right now so I can't do that...
Thanks man.
Lyall
I can't believe I didn't switch the motor leads...I don't have the software hookup kit right now so I can't do that...
Thanks man.
Lyall
#6
Is the flashing yellow a normal thing now? I heard it now means there is no timing advance set on the motor but the instructions say otherwise...????
Thanks in advance.
LIP
Thanks in advance.
LIP
#9
#10
btw I have a mountain of extra wire coming from the castle motor to the esc...are most people just cutting them shorter?