Originally Posted by SeanV

This might seem like a stupid question but my understanding is...

When you load the no timing software onto an XeRun, shouldn't there be a blinking light (hence blinky mode) to indicate to scrutineers that the ESC is running no timing and is in blinky mode?

I have loaded the no timing software (V3_508_NO timing)onto my Xerun 60A and there is no blinky light - what gives?
(It definitely has the no timing software loaded, in Advanced settings of the USB link, all the timing settings are grayed out which is what I would expect.)

Originally Posted by puma303

a little question :

there is a way to know if it's released a new firmware version of my esc without having to connect it to my PC ( i've got the XERUN-150A-SD ) ?

i see that the downloaded version for usb link software is from 12/06/12, is right? i use already this version...or there is a new version?

Originally Posted by COBRARACING

There is no new software for the 150amp esc .Yes you need to use your pc and liad the usb to see it there are any updates.

Originally Posted by Wildcat1971

did you recalibrate the esc after you made the changes?

Originally Posted by bkspeedo

Has anyone tried increasing the cap size on a HW ESC to increase brakes?

I'm using a Justock with V3_508_NO_timing FW in a 17.5 and 13.5 TC and the brakes are horrible. 2 different motor's; 17.5 Thunder Power and the 13.5 Revtech.

I did not have this issue with a Tekin w/223 fw.

I love this ESC but it needs better braking. Any help would be appreciated.

Originally Posted by chris_dono

If it's a V2.1 then try the following:
set your end point for throttle/brake to 95%
calibrate your speedo
set your end point back to 100%
set brakes to 100%

This should be enough hopefully, if not, please get in touch !

Originally Posted by bkspeedo

I believe i tried this technique but I'll try it again this wed when i race again.

Originally Posted by COLD AS ICE

Hey Brent, have you tried setting the reverse force to 100% as well as the brake force. Make sure it's in FWD only mode and this should help make the brakes a little stronger.

Originally Posted by COLD AS ICE

Hey Brent, have you tried setting the reverse force to 100% as well as the brake force. Make sure it's in FWD only mode and this should help make the brakes a little stronger.