novak gtb programming trouble please help
#1
novak gtb programming trouble please help
Hey there got a novak gtb 2nd hand and i am setting up i a xxxt can't get reverse to work have gone through the instructions to change profile to #5 and done one touch setup but no luck any ideas.
michael
michael
#2
Company Representative
Because I am not part of Novak's technical support group, I suggest you email [email protected] with your question, Our regular CS/Tech Support hours can be located here. Before emailing, take a moment to review the instructions (trouble-shooting guide) originally included with your Novak Item:
Novak Instruction Downloads
Trouble-shooting TeamNovak's One Touch™ Speed Controls
Please make your initial email as detailed as possible. Include:
~ warranty claim?
~ speed control (brand/model)
~ motor (brand/wind)
~ rotor (old/new)
~ connectors used
~ servo (brand/model)
~ radio system (receiver/transmitter)
~ vehicle & gearing
~ battery, brand (c rating/capacity)
~ lipo cut-off, on/off
~ any external modules (BEC/brand, Glitch Buster)
~ other important info: water damage, corrosive chemical sprays, excess heat, etc
~ warranty claim?
~ speed control (brand/model)
~ motor (brand/wind)
~ rotor (old/new)
~ connectors used
~ servo (brand/model)
~ radio system (receiver/transmitter)
~ vehicle & gearing
~ battery, brand (c rating/capacity)
~ lipo cut-off, on/off
~ any external modules (BEC/brand, Glitch Buster)
~ other important info: water damage, corrosive chemical sprays, excess heat, etc
#3
Tech Adept
SAME THING HAPPEND HERE
MAKE SURE ITS ALL PLUGGED IN RIGHT INTO THE RECEIVER!! OR IT WONT WORK
MAKE SURE ITS ALL PLUGGED IN RIGHT INTO THE RECEIVER!! OR IT WONT WORK
#5
Hey guys thanks for all your input. turns out i am stupid i just wasn't holding the button down long enough for all 4 leds to light up whoops. now it works fine. thanks again
Last edited by gnatsum69; 01-22-2010 at 04:14 PM.