Noble NB4 endpoint issue after FW update
#1
Noble NB4 endpoint issue after FW update
Hi Guys,
I just updated my NB4 firmware after a couple of years to 2.1.102FCC and both my steering and throttle channels are not going to their set endpoints. All endpoints are set to 100% But here are the maximum they’re showing at full deflection.
Steering(Ch1) 92% to the Right and 88% to the left
Throttle(Ch2) 64% Forward and -31% reverse
The trims and subtrims are all set to 0 and at 0, the steering shows 4% to the right. The channels 3 and 4 dials are functioning normally with 0 at centerpoint and 100% either way.
Any help would be greatly appreciated.
Best,
John
Essex, MA
I just updated my NB4 firmware after a couple of years to 2.1.102FCC and both my steering and throttle channels are not going to their set endpoints. All endpoints are set to 100% But here are the maximum they’re showing at full deflection.
Steering(Ch1) 92% to the Right and 88% to the left
Throttle(Ch2) 64% Forward and -31% reverse
The trims and subtrims are all set to 0 and at 0, the steering shows 4% to the right. The channels 3 and 4 dials are functioning normally with 0 at centerpoint and 100% either way.
Any help would be greatly appreciated.
Best,
John
Essex, MA