m henry

iTrader: (26)

i have a m-8 that will power up but will not transmit a signal to the reciver.i have tried three different modules and recivers. any help would be appriciated

blackest

iTrader: (2)

This may seem obvious, but do you have matching crystals? Have you tried a different set of crystals, as they aren't too difficult to break?

Also, do you have power going to the receiver? Is the receiver connected properly, i.e. correct polarity?

m henry

iTrader: (26)

yes have tried all of the above.correct polarity and all.

revo61

iTrader: (18)

Are you turning on the display? You can turn on the display and it will look like it is on but not.

JamesnMeyer

iTrader: (41)

Funny you mention that. I had that very issue. I was turning on the switch on top and ended up finding the real power switch two days later Needless to say it worked very well after I turned it on

m henry

iTrader: (26)

turning the power on not the display.