WTB: .28 Nitro engine for Truggy.
#1
WTB: .28 Nitro engine for Truggy.
*** No longer needed..... Thanks..*** Just as title states. I purchased a Truggy and the seller (Not from RCTech.) was not 100% up front about the engine. Engine is worn out, so I now need a replacement. Dont have alot to spend since I just bought the truggy. Looking for a good clean used .28. Brand does not matter as long as its in good running condition, unlike the paper weight I have now. I'm eying a couple on ebay, but thought I'd ask you guys to see if you happen to have one laying around that your willing to sell.
Thanks....
Thanks....
Last edited by JDMbyBlood; 04-06-2015 at 02:06 PM.
#2
Just throw a new piston an sleave in it! Save extra $$$
#3
Thanks for the reply. Thought about it, but with it also having a cooling fin broke off it, I thought it might better just to replace the whole engine. I found a few on ebay in the $50.00 range. Not looking to spend a lot on it. Paid $125.00 for the truggy shipped.
#4
Tech Addict
iTrader: (1)
I have a nice used Wasp .28 I'll let go for $50. It has very little run time, and regardless of what anyone says, this motor runs hard and is not hard to tune at all. I had it in a Kyosho 777 for about 3-4 weeks. It ran hard after break in, like the one I had before it in my savage 25. I have no use for it anymore, as I switched primarily to electric.