Need bind plug! PM ME!~
#3
#7
Tech Fanatic
iTrader: (5)
All that is being done is jumping the outter 2 pins together on the bind port of the rx. So any way you can accomplish this will save you the time and money of getting one otherwise. Even single jumpers connected together and on those 2 pins would do it. I don't know why they omitted the bind switch on the rx, the previous rx's had them which made binding much easier.
#8
I'm thinking its gonna cost roughly $20 bucks
#9
All that is being done is jumping the outter 2 pins together on the bind port of the rx. So any way you can accomplish this will save you the time and money of getting one otherwise. Even single jumpers connected together and on those 2 pins would do it. I don't know why they omitted the bind switch on the rx, the previous rx's had them which made binding much easier.
#10
Tech Adept
iTrader: (18)
This might be a two-person job if you don't have a servo lead you can
sacrifice... I don't know what happens if you touch the center pin to
one of the other 2 or both at the same time...electricity is fast and it
could damage the receiver if you touch the wrong 2 pins with power
available......
Scott
sacrifice... I don't know what happens if you touch the center pin to
one of the other 2 or both at the same time...electricity is fast and it
could damage the receiver if you touch the wrong 2 pins with power
available......
Scott