FS: Brushless Hobbies LT4-120 amp esc/Castle 1410 motor
#1
FS: Brushless Hobbies LT4-120 amp esc/Castle 1410 motor
Selling a spare esc/motor so I can fund some spare parts/tires for my new buggy...
Brushless Hobbies LT4-120amp ESC... I cooked the bec using a savox servo... so You will NEED an external bec. ($10 for the hobby wing 3amp one... or $20 for the castle creations 10amp programmable bec.)
It will come with the programing fob.
Motor was run on a Stampede 4x4 that I had converted into a truggy. It's the 1410 3800kV with the 5mm rotor shaft.
I made a litte video of the combo working so you can be confident about buying it.
$85 shipped con us, paypal only. Thanks.
https://www.youtube.com/watch?v=kBxnqxsfWO0
I didnt have this combo together last... I had the esc hooked up to a motor that had solder tabs directly on the end bell, so I quickly and crudely tossed some 4mm bullets on it... I will be taking off the bullets, and the traxxas connector, unless you want them... then I'll clean up the bullets, and put some heat shrink on for you.
Here is a pic, just in case you can't watch the video...
Brushless Hobbies LT4-120amp ESC... I cooked the bec using a savox servo... so You will NEED an external bec. ($10 for the hobby wing 3amp one... or $20 for the castle creations 10amp programmable bec.)
It will come with the programing fob.
Motor was run on a Stampede 4x4 that I had converted into a truggy. It's the 1410 3800kV with the 5mm rotor shaft.
I made a litte video of the combo working so you can be confident about buying it.
$85 shipped con us, paypal only. Thanks.
https://www.youtube.com/watch?v=kBxnqxsfWO0
I didnt have this combo together last... I had the esc hooked up to a motor that had solder tabs directly on the end bell, so I quickly and crudely tossed some 4mm bullets on it... I will be taking off the bullets, and the traxxas connector, unless you want them... then I'll clean up the bullets, and put some heat shrink on for you.
Here is a pic, just in case you can't watch the video...
Last edited by erevo1*16; 04-12-2014 at 05:35 PM.