Pro-Line Pro2 complete with Tekin

Reply Subscribe

Thread Tools

Search this Thread

11-28-2013, 09:20 PM

moreda_5

Tech Initiate

Thread Starter

iTrader: (3)

Join Date: Jan 2013

Location: Cali

Posts: 34

Trader Rating: 3 (100%+)

Pro-Line Pro2 complete with Tekin

I built this set up just before ProLine released their PRO-2 roller but I used all the same parts in the Pro-2 kit less PRO-2 Hard Anodized Pivot Ball & Rod End Set as I wasn't aware these were available. Being should WITH OUT the Spektrum receiver you see on the car but being sold with receiver and controller so it is a ready to run.

This car has the following:
PRO-2 LCG Performance Chassis
PRO-2 Front Hub Kit
PRO-2 Hard Anodized Front Hinge Pin Brace
PRO-2 Rear Bumper
PRO-2 Front Bumper and Bulkhead
PRO-2 Hinge Pin Set
PRO-2 Front Clamping Hex
PRO-2 Rear Clamping Hex
PRO-2 ProTrac Axle Kit
Pro-Line Split six Wheels
Pro-Line Performance Transmission
Pro-Line Performance Steering Kit
ProTrac Suspension Kit 2WD
Pro-Line Heavy Duty Motor Washers and Screws
Extended Front & Rear Body Mounts (Slash 2WD)
Tekin RS Pro ESC
Tekin 7.5 motor
AKA Enduro Tires
Spektrum S6070 servo
Blue Ano steering horn

Extras:
Pro-Line Transmission Slipper Pads Replacements
Tekin Hot wire hit.
4mm Serrated Wheel Lock Nuts

The bad:
The shock shafts have had the ti-nitride worn off and could use replacing.

$400 obo complete possibly into selling it as a roller for $230