Here we go! After trying heli's, I realized that I need to stay on the ground. These have all been sitting for at least a year, just decided to sell them so someone else can enjoy them! To be completely honest, I don't know what this stuff is worth so if I'm high, don't hesitate to bump me down! The last time I took each one out, everything functioned properly unless otherwise noted. Everything includes shipping unless noted. Let's begin!
1: Spektrum DX7 Transmitter only ($60) SOLD to mtrucker!! - has a LIPO and NIMH battery pack, I don't remember if the antenna is broken, but it stays on fairly well, I think a new one is around $10. There is a little of the paint coming off right under the antenna, purely cosmetic though.
2: HK450 TREX clone Heli ($130) SOLD!!!- may have around 15 minutes of use. 4000KV brushless motor, can't remember the ESC (but it runs it well), Viverrine VS1900 servos up front, Vampowerpro VP-LDS-29 tail servo, Esky 6CH 2.4Ghz tx and rx, Eflite EFLRG110HL gyro. Tail blades are a little chipped. If you go with (or close to) my asking price, I'll throw in a 11.1v lipo that has not even an entire flight through it (turnigy 2200mah 25C) SPARES: pinions, servo horns, tail blade (x2 I think), and I'll throw in a little blade balancer
3: JETI Advance 30 Plus brushless ESC ($15) SOLD to walthor!! - I don't know much about this ESC, a buddy gave it to me and I have no use for it.
4: NEU (?) brushless motor ($15) SOLD to walthor!! - again, don't know much about this. I have never plugged it up, so I don't know if it works or not. It will spin in your hand, doesn't feel like its binding at all. The markings on the can (as far as I can tell) are as follows: 1105/3.5Y/3.2
5: Eflite Blade CP Pro ($80) - I have the original box. Has a brushless motor, Eflite 72Mhz 6CH tx and rx, Hobbywing Pentium 18-A ESC (may have the programmer too), flyingsport.com landing gear, metal head, CF (appearing I think) tail blade. The blades are chewed up, they are the plastic ones. I think the tail boom may be cracked, but still holds up fine. SPARES: stock landing gear, flyingsport.com landing gear set, extra chassis, all stock electronics and head (may be missing a part or two on the head), extra main gear
6: Walkera 4#3 ($60) SOLD!!! - I have the original box. Brushed motor, metal head and swashplate, 2.4Ghz WK-2401 tx and rx, comes with 2 lipo batteries and stock charger (it is designed to charge the lipos). Head blades are marked up a little on the very outside. SPARES: stock FM radio (missing battery tray, but uses the same as the WK-2401), main gear (x1), metal blade holder (x1), plastic head (for parts) (x1), rotor head (x1), balance bar (x1), tail blade (x1), tail boom (x2), sets of new blades (x2)
7: Walkera 4G3 ($90) SOLD!!! To slafontaine88- I have the original box. Brushless main motor (brand new), metal head and swashplate, 2.4Ghz WK-2601 tx and rx, comes with 2 lipo batteries and stock charger (again, designed to charge the lipos). Head blades are marked up a little on the very outside. SPARES: main shaft (x2), tail gear set (x1), tail knighthead (x2), tail boom (x2), tail rotor (x2), stock blade set (x1), carbon fiber blade set (x1)
8: Blade CX2 set ($90) - both have stock electronics and the metal head, the red one is basically ready to fly, the yellow one is missing a transmitter. You get both for the price. The red one has an Eflite 72Mhz 4CH tx and rx, custom blade holders, and has 2 Eflite 11.1V 800mah batteries. No charger with this one. SPARES: pretty much enough to rebuild these things over and over again: chassis (x3), outer shaft (x1), inner shaft (x1), gears (x9), assorted head parts (x3), full metal swashplate/blade holder/head (x1), extra Eflite blades (a few), upper and lower blade sets for the custom blade holder (x5 sets of each)
RANDOM GAS HELI/AIRCRAFT PARTS: got these from a buddy, have no idea what they are used for or what they do...
9: rcexl ignition use mini tachometer v1.1 - 3 available, retail is $20. Asking $10 including shipping, or $25 for all three. Two are brand new in package!
10: rcexl ignition test kit - retail is $13, just throw me an offer. If I get the shipping price ill be good!
11: rcexl opto gas engine kill switch v1.2- 3 all brand new in package, retails for $20 each. $10 each gets them, or $25 for all three.
12: rcexl transistors of some type - got two, throw me money for shipping and they're yours.
IF YOU WANT ALL THE RANDOM STUFF: $45 shipped out
THINGS I AM INTERESTED IN: brushless parts or lipo batteries for an E-Maxx; maybe another truck/buggy/truggy; of course, good ol' cash (or PayPal really)
IF WE ARE TRADING: if your feedback is lower than mine, you ship first. If my feedback is lower, I'll ship first.
SHIPPING: Please understand that I work full time and am also a full time college student. I try my best to ship as fast as I can, usually in a day or two. I expect payment before I ship, and will provide a tracking number (with insurance) as soon as I get one.
PRICES: I'm feeling negotiable, no good offer will be turned away! Remember, the worst thing I can do is say no!
Again, all of these were running before they were stored in the garage. Due to the nature of these wonderful hobbies, everything is AS-IS. I do try my best to tell what I think is wrong with anything. If you would like more pictures, just ask and I can either put them up on here, email them to you, or send a PM with them.
You can reach me on here or at firstname.lastname@example.org
with any questions. Email will probably get you a faster response as it updates immediately on my phone.
Hoping to do some business soon!!!!! I want someone else to enjoy these the way they were meant to be enjoyed.