rider313

iTrader: (94)

I have My CRE P5XLT for sale. This is Neals Buggy Mod, It's a Ripper. The motor has 3 gallons on it including break in. I ran Werks 30% nitro for the entire duration. It was in Neal's Shop less then 1/2 a gallon ago. He suspected my original block was bad so he threw a new one on, He also installed TKO ceramic front and rear bearings. He also gave it a Pinch to keep it fresh and running 100%. It still has its Pinch as Seen in pics below.

I stand behind my Motors 100%, My trader rating is perfect with 2 motors sold and two Given away for free. All have reported back 100% with great results.

I would like to get SOLD shipped for this motor, Paypal Only, Lower 48. Will ship to Canada for a additional $5.

Now the Pics.

Everything you will receive.


Internals


Inside block


Crank


Piston head and Side



Sleeve side and inside



Piston in sleeve as high as i can push it with fingers, still has solid Pinch!


Head Button, (glow plug is a Dead plug i cleaned with motor spray to use as a seal to keep dust out. Do not run this plug!)


Neals Blocked Vacuum port.



Thanks for looking, Feel free to ask Any Questions!

Motorman007

iTrader: (89)

bump for a clean motor

rider313

iTrader: (94)

Thanks.

Dez

iTrader: (89)

Pm'd

rcuser567345

iTrader: (7)

I can vouch for the performance of this engine, it sure is a ripper Even when using my buggy mod P5 in my truggy, its super fasttt with tons of grunt for a truggy and top end for those long straightaways! And with those ceramics, it will rev faster and better, you will also get excellent run time out of this engine.