// CLEANOUT SALE \\ JAMMIN / XRAY / TRANSPONDER / TEKIN / TRAXXAS /
09-14-2012, 02:31 AM
#1
// CLEANOUT SALE \\ JAMMIN / XRAY / TRANSPONDER / TEKIN / TRAXXAS /
Xray XT8 - $250 PLUS SHIPPING (Starter box battery is quite heavy)
Rolling chassis plus engine and pipe, lots of parts, starter box, glow igniter.
I got this used, and never really got around to messing with it. I have run it twice. It has one broken body post, 4 new in package will be included.
It has a Sirio .21 engine. I've only used this truck twice, so I have limited experience with the engine, it came in the truck used. It starts right up, sounds like it's running great, until you actually drive it. It takes off quickly, but never seems to be able to 'clear out' and fully rev, but it will with the truck off the ground. I've tried tuning it as much as I could, it made no improvements. So it works, but not at full potential.
Extras included...
JR ST-126 MG throttle/brake servo installed
Reedy 1600 mAh 5-cell flat pack rx battery with charger
Starter box with 12v gel-cell with charger
Hot Shot 2 glow ignitor with charger
AKA I-Beams - Around 50-75% tread
Pro-Line Holeshots - Balanced, very worn, maybe 20% tread left
Xray Parts NIP
2x 1308 - body posts
2x 3170 - pivot ball x4
2x 2150 - front upper arm ball joint
2250 - steering block, right v2
2001 - diff bulkhead set rear
2210 - composite c hub right
3118 - rear lower supension arm
2x 2128 - front lower suspension arm
2000 - diff bulkhead set front
2220 - composite c hub left
2662 - steering ball joint
2297 - steel steering bushing
2148 - front upper arm
Ofna - 30800 - 1/8 throttle/brake linkage NIP
Generic air filter oil - about 90% full
Dynamite - pink silicone parts with air filter NIP
-------------------------------
Jammin SCRT10 - $200 PLUS SHIPPING SOLD
I bought this brand new, raced it for about 2 seasons. Strictly a track truck, not a basher. Raced on blue groove clay track.
Comes with 2 bodies.
Aluminum upgrades installed - Front C-Hubs, Steering Knuckles, Wheel Hexes, Front Shock Tower, Steering Drag Link, Servo Horn
Rc-Monster custom lay-down battery tray with velcro straps
Savox SC-1268mg servo installed
4 sets of tires...
Pro-Line Calibers - M3 compound, about 50% tread
JC Concepts Barcodes - Clay compound, about 25-50% tread left (2 sets)
AKA Wishbones - Clay compound, about 40% or so tread
-------------------------------
My Laps transponder with mount - SOLD
-------------------------------
Tekin SC4X 550 size 5.5T sensored motor. About 6 races of use in the Jammin listed above - $80 SHIPPED SOLD
-------------------------------
Traxxas Big Bore shocks for Maxx trucks. Brand new, never opened in package - $60 SHIPPED
-------------------------------
PM me for any other details. I have paypal, but I will be adding the actual shipping cost if you are buying one of the trucks, so I don't want payments just showing up unexpectedly.
I will go by first PM, first serve rules.
Thanks for looking
Rolling chassis plus engine and pipe, lots of parts, starter box, glow igniter.
I got this used, and never really got around to messing with it. I have run it twice. It has one broken body post, 4 new in package will be included.
It has a Sirio .21 engine. I've only used this truck twice, so I have limited experience with the engine, it came in the truck used. It starts right up, sounds like it's running great, until you actually drive it. It takes off quickly, but never seems to be able to 'clear out' and fully rev, but it will with the truck off the ground. I've tried tuning it as much as I could, it made no improvements. So it works, but not at full potential.
Extras included...
JR ST-126 MG throttle/brake servo installed
Reedy 1600 mAh 5-cell flat pack rx battery with charger
Starter box with 12v gel-cell with charger
Hot Shot 2 glow ignitor with charger
AKA I-Beams - Around 50-75% tread
Pro-Line Holeshots - Balanced, very worn, maybe 20% tread left
Xray Parts NIP
2x 1308 - body posts
2x 3170 - pivot ball x4
2x 2150 - front upper arm ball joint
2250 - steering block, right v2
2001 - diff bulkhead set rear
2210 - composite c hub right
3118 - rear lower supension arm
2x 2128 - front lower suspension arm
2000 - diff bulkhead set front
2220 - composite c hub left
2662 - steering ball joint
2297 - steel steering bushing
2148 - front upper arm
Ofna - 30800 - 1/8 throttle/brake linkage NIP
Generic air filter oil - about 90% full
Dynamite - pink silicone parts with air filter NIP
-------------------------------
Jammin SCRT10 - $200 PLUS SHIPPING SOLD
I bought this brand new, raced it for about 2 seasons. Strictly a track truck, not a basher. Raced on blue groove clay track.
Comes with 2 bodies.
Aluminum upgrades installed - Front C-Hubs, Steering Knuckles, Wheel Hexes, Front Shock Tower, Steering Drag Link, Servo Horn
Rc-Monster custom lay-down battery tray with velcro straps
Savox SC-1268mg servo installed
4 sets of tires...
Pro-Line Calibers - M3 compound, about 50% tread
JC Concepts Barcodes - Clay compound, about 25-50% tread left (2 sets)
AKA Wishbones - Clay compound, about 40% or so tread
-------------------------------
My Laps transponder with mount - SOLD
-------------------------------
Tekin SC4X 550 size 5.5T sensored motor. About 6 races of use in the Jammin listed above - $80 SHIPPED SOLD
-------------------------------
Traxxas Big Bore shocks for Maxx trucks. Brand new, never opened in package - $60 SHIPPED
-------------------------------
PM me for any other details. I have paypal, but I will be adding the actual shipping cost if you are buying one of the trucks, so I don't want payments just showing up unexpectedly.
I will go by first PM, first serve rules.
Thanks for looking
Last edited by SloRacer1080; 11-06-2012 at 01:57 PM.
09-16-2012, 03:57 PM
#4
Payment for rc4 transponder sent! thanks
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
