FS: NEW Asylum Capacitors
#1
FS: NEW Asylum Capacitors
Capacitors are an essential part of today's electronic systems. Although some set ups can be ran without a cap, others will glitch and cut out during moments of high current draw. This is known as "Browning Out."
To tell if your receiver is browning out, have a pit buddy hold your RC while pulling full throttle on and off, and turning your wheels left and right as fast as possible. If you see the light on your RX or transponder begin to flicker you need to install a capacitor to prevent further glitching.
This happens when your ESC and servo (or both servos in gas cars) are drawing a lot of electricity at the same time. This can cause the electronics to act erratic such as glitching, or your transponder shooting a low signal resulting in a missed lap. But by simply plugging an appropriate sized cap into an empty port on your RX, all glitching will be eliminated.
Asylum caps have a higher storage amount than other's on the market, so once you plug in.. You will never have to deal with a glitch again!
Price is $6.50 shipped to your door!
To tell if your receiver is browning out, have a pit buddy hold your RC while pulling full throttle on and off, and turning your wheels left and right as fast as possible. If you see the light on your RX or transponder begin to flicker you need to install a capacitor to prevent further glitching.
This happens when your ESC and servo (or both servos in gas cars) are drawing a lot of electricity at the same time. This can cause the electronics to act erratic such as glitching, or your transponder shooting a low signal resulting in a missed lap. But by simply plugging an appropriate sized cap into an empty port on your RX, all glitching will be eliminated.
Asylum caps have a higher storage amount than other's on the market, so once you plug in.. You will never have to deal with a glitch again!
Price is $6.50 shipped to your door!
Last edited by So*Cal AFDude; 04-26-2012 at 05:40 PM.
#3
Tech Elite
iTrader: (12)
Here ya go mate, two reputable folks I've used before:
http://www.heatshrink.com/prod-printing-shmark.htm
http://www.buyheatshrink.com/heatshr...k-printing.htm
Cheers!
http://www.heatshrink.com/prod-printing-shmark.htm
http://www.buyheatshrink.com/heatshr...k-printing.htm
Cheers!
#4
Pm'd