SUMMIT roller customized rear steer 1/6th
09-16-2011, 07:36 AM
#1
SUMMIT roller customized rear steer 1/6th
Traxxas summit roller - highly customized.
- extended to 1/6 size
- custom rear steering
- helios body
- all diffs/servos work
- 2 speed tranny installed (after picture was taken)
- has 1 torn tire
looking for $350 shipped obo
- extended to 1/6 size
- custom rear steering
- helios body
- all diffs/servos work
- 2 speed tranny installed (after picture was taken)
- has 1 torn tire
looking for $350 shipped obo
09-17-2011, 08:02 AM
#2
- it has a customized center drvie shaft (not in the original picture) using a male to female traxxas drive shaft. (so its still 4wd)
- It has (3) TowerPro 208oz of torque, metal geared servos for steering.
- rit dye blacked out chassis
- custom rear chassis which incorporates a second front steering assembly
- black steel pushrods.
- customized 1/6 sized chassis. Created from two front summit chassis joined together.
- nice pre-painted helios body (my second painted body)
- the second diff servo is located in the back (closer to the rear diff lock)
- all 3 mini servos are present(diff x2, tranny)
- water proof traxxas rx box.
- the front and rear diffs are wired together to lock at the same time.
- - due to the fact I ran this truck using a 3 channel spektrum radio.
- - but if desired they can be re-wired to their original configuration.
- It has (3) TowerPro 208oz of torque, metal geared servos for steering.
- rit dye blacked out chassis
- custom rear chassis which incorporates a second front steering assembly
- black steel pushrods.
- customized 1/6 sized chassis. Created from two front summit chassis joined together.
- nice pre-painted helios body (my second painted body)
- the second diff servo is located in the back (closer to the rear diff lock)
- all 3 mini servos are present(diff x2, tranny)
- water proof traxxas rx box.
- the front and rear diffs are wired together to lock at the same time.
- - due to the fact I ran this truck using a 3 channel spektrum radio.
- - but if desired they can be re-wired to their original configuration.
09-19-2011, 06:46 PM
#3
to the top
09-22-2011, 01:28 PM
#4
bump up
09-24-2011, 06:14 AM
#5
just putting it on top
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
