rb s5 l2g(turbo button), dynamite 5port(turbo button)&losi balancer
04-23-2011, 06:17 PM
#1
rb s5 l2g(turbo button), dynamite 5port(turbo button)&losi balancer
1. losi tire balancer barely used(no clay included, will include original plastic case)
http://www.amainhobbies.com/product_...Balancing-Clay
sold
2. rb s5 l2g w/turbo button (can include standard) 5gallons of sidwinder 30% and uses odo turbo plug. possibly slight pinch, rod(has kink at top of stroke) and rear bearing could be needed. put new front bearing in 1/2 gallon ago(*note it runs fine but was stalling at end of straight last time ran, didnt try to re-tune it or tear down although it is clean). In original box sold pndng pymnt thank u
3. dynamite .21 mach 2 5 port runs. about 4gal of sidewinder 30% and uses odo turbo plug. has grp turbo button thats pressed into the cooling head. very reliable mill
http://www.amainhobbies.com/product_...G-Buggy-Engine
in original box w/restricters SOLD
cant post pics. email pics in few days. paypal and shipping usps priority w/tracking. thanks
http://www.amainhobbies.com/product_...Balancing-Clay
sold
2. rb s5 l2g w/turbo button (can include standard) 5gallons of sidwinder 30% and uses odo turbo plug. possibly slight pinch, rod(has kink at top of stroke) and rear bearing could be needed. put new front bearing in 1/2 gallon ago(*note it runs fine but was stalling at end of straight last time ran, didnt try to re-tune it or tear down although it is clean). In original box sold pndng pymnt thank u
3. dynamite .21 mach 2 5 port runs. about 4gal of sidewinder 30% and uses odo turbo plug. has grp turbo button thats pressed into the cooling head. very reliable mill
http://www.amainhobbies.com/product_...G-Buggy-Engine
in original box w/restricters SOLD
cant post pics. email pics in few days. paypal and shipping usps priority w/tracking. thanks
Last edited by 8&stuff; 05-13-2011 at 07:46 PM.
1st $40shipped takes rb
05-11-2011, 02:53 PM
#10
I'll take tire balancer
PM Sent
Thanks
PM Sent
Thanks
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
