Nitro engine - fleet reduction!
#1
Nitro engine - fleet reduction!
RC Fans here are a few of my mills that I bought new and put a gallon or more on, specifics will be listed for each mill, and have now been put into the backup box for a later day. Well the later day never came and now I have a few too many .21's sitting on the bench. All of these motors were preheated before every start (I leave the heater throughout the race day which results in less wear and tear during cold starts) Sidewinder 30% race blend was used in all motors.
To start:
GoEngine 3 port turbo head race engine. Right at 3 gallons of run time. This motor was my first Go motor and it never let me down, quite a lot of balls for a 3 port. However, our track went from 680'to almost 1300' so I needed a bit more on the top, and into the backup box this little fella went. Motor was always preheated before start, thanks to my Powerhouse motor warmer. Runs great and has good pinch. $75.00 shipped in the lower 48:
http://www.go-engine-usa.com/index.p...category_id=29
SOLD Now for the Big Dawg, Novarossi FMS 7port race engine. This was to be my go to motor. However, after putting it through the usual break in process I could never get it to do what I wanted it to. So, you guessed it, back in the pitbox it went. I have a lot of money in this mill but it's need to leave as I'm tired of looking at it, so - $125.00 shipped in the lower 48
http://www.novarossiusa.com/product_...roducts_id=904
Please pm me for faster response time. Thank you for looking!
To start:
GoEngine 3 port turbo head race engine. Right at 3 gallons of run time. This motor was my first Go motor and it never let me down, quite a lot of balls for a 3 port. However, our track went from 680'to almost 1300' so I needed a bit more on the top, and into the backup box this little fella went. Motor was always preheated before start, thanks to my Powerhouse motor warmer. Runs great and has good pinch. $75.00 shipped in the lower 48:
http://www.go-engine-usa.com/index.p...category_id=29
SOLD Now for the Big Dawg, Novarossi FMS 7port race engine. This was to be my go to motor. However, after putting it through the usual break in process I could never get it to do what I wanted it to. So, you guessed it, back in the pitbox it went. I have a lot of money in this mill but it's need to leave as I'm tired of looking at it, so - $125.00 shipped in the lower 48
http://www.novarossiusa.com/product_...roducts_id=904
Please pm me for faster response time. Thank you for looking!
Last edited by rcjunky10; 01-15-2011 at 06:52 AM.