FS: **Checkpoint TC1030 Chargers**
08-22-2010, 11:58 PM
#1
FS: **Checkpoint TC1030 Chargers**
http://www.rcuniverse.com/magazine/a...article_id=891
This functions perfectly. It has sat in my pit room and has been babied. While not perfectly NIB, it is as close as you can get without leaving it in the box. Includes a temp sensor.
- Easy to read blue back-lit display
- LiPo-, NiCd- and NIMH-compatible!
- Five fast-charge modes, including 3-step and 4-step.
- Features linear and high-amp, custom 20A and 30A pulsed discharge functions, plus a Dead Short mode for extreme conditioning of high-powered racing packs.
- Includes motor test and two break-in modes: 1-step – and a 4-step mode with programmable voltage and cool-off times!
- Offers 10-pack memory – and the ability to recall data for up to 10 full cycles.
- Voltage cut-off adjusts from as little as 1mV or 2mV to a maximum of 25mV.
- Twin cooling fans improve efficiency and extend life!
$80 shipped to L48
Paypal preferred
I'll get the pics up later this week.
This functions perfectly. It has sat in my pit room and has been babied. While not perfectly NIB, it is as close as you can get without leaving it in the box. Includes a temp sensor.
- Easy to read blue back-lit display
- LiPo-, NiCd- and NIMH-compatible!
- Five fast-charge modes, including 3-step and 4-step.
- Features linear and high-amp, custom 20A and 30A pulsed discharge functions, plus a Dead Short mode for extreme conditioning of high-powered racing packs.
- Includes motor test and two break-in modes: 1-step – and a 4-step mode with programmable voltage and cool-off times!
- Offers 10-pack memory – and the ability to recall data for up to 10 full cycles.
- Voltage cut-off adjusts from as little as 1mV or 2mV to a maximum of 25mV.
- Twin cooling fans improve efficiency and extend life!
$80 shipped to L48
Paypal preferred
I'll get the pics up later this week.
Last edited by andrewdoherty; 09-26-2010 at 01:58 PM.
08-25-2010, 03:53 PM
#4
Does this balance charge lipos?
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
