Aluminum T Plates Kyosho Ultima SC/DB/RT5/RB5
#121
Tech Elite
iTrader: (121)
Hey guys,
I wanted to give you another update. I talked to the machinist today. It took longer to get the materials than we originally thought. He also has a job he needs to finish before he can set up our parts. The first sample should ship out tomorrow. I should be able to check it out over the weekend and then give him the go ahead on Monday. It will take about a week to get the parts once he starts machining. So, in short, the plates should be available around the 3rd of October.
Thanks for your patience,
Chris
I wanted to give you another update. I talked to the machinist today. It took longer to get the materials than we originally thought. He also has a job he needs to finish before he can set up our parts. The first sample should ship out tomorrow. I should be able to check it out over the weekend and then give him the go ahead on Monday. It will take about a week to get the parts once he starts machining. So, in short, the plates should be available around the 3rd of October.
Thanks for your patience,
Chris
#122
Tech Elite
iTrader: (121)
Hi guys,
I finally received the prototype plate last week. There were a couple minor fitment issues, mainly the clearances on everything were way too tight. I have communicated these changes to the machinist and he is busy milling the parts as I type. The plates will be available early next week.
I have added them to my website:
Attebery Performance Engineering
Thanks,
Chris
I finally received the prototype plate last week. There were a couple minor fitment issues, mainly the clearances on everything were way too tight. I have communicated these changes to the machinist and he is busy milling the parts as I type. The plates will be available early next week.
I have added them to my website:
Attebery Performance Engineering
Thanks,
Chris
Last edited by ChrisAttebery; 11-14-2011 at 09:24 PM.
#123
Tech Elite
iTrader: (121)
Hey guys,
This project has taken forever to get done, but the parts should be mailed out by the end of the week (11/11/11). I received them on Thursday but there was one small problem and I gave them back to the machinist to correct it.
I ran one at Nor-Cal Hobbies yesterday and it worked great.
The plates are available on my website:
Attebery Performance Engineering
Thanks for your patience,
Chris
This project has taken forever to get done, but the parts should be mailed out by the end of the week (11/11/11). I received them on Thursday but there was one small problem and I gave them back to the machinist to correct it.
I ran one at Nor-Cal Hobbies yesterday and it worked great.
The plates are available on my website:
Attebery Performance Engineering
Thanks for your patience,
Chris
Last edited by ChrisAttebery; 11-06-2011 at 09:04 AM.
#124
Tech Elite
iTrader: (121)
CHASSIS PLATES ARE IN STOCK AND SHIPPING!!!
The plates are $25 each and available through my website.
Attebery Performance Engineering
I've started a new thread in the for sale forums for questions and comments:
http://www.rctech.net/forum/r-c-item...ml#post9911950
Thanks for your patience.
Chris
The plates are $25 each and available through my website.
Attebery Performance Engineering
I've started a new thread in the for sale forums for questions and comments:
http://www.rctech.net/forum/r-c-item...ml#post9911950
Thanks for your patience.
Chris