Caster ZX1.5r Factory buggy w/tons of nip parts CHEAP
#1
Caster ZX1.5r Factory buggy w/tons of nip parts CHEAP
Started a new job and had to relocate, far too busy to mess with this car right now, which is also why I did not clean it....sorry.Car is about 1.25 gallons old, has tons of NIP parts, also has been upgraded with Mugen MBX6 lower front arms with Thunder tiger pillow balls in them, also 2 tanks ago I installed a full set of Mugen outdrives(about $60), car has Diggity Designs carbon towers front and rear, has the tal front on it and a new short tower included as well. Linkage setup was fully custom by me in an effort to test weight placement, I found it to work very well(clean pic is from when i installed it), stock radio tray is also included. Swapped rear end setup with custom sway bar mount. The rear chassis brace where it attaches to the bulkhead has a screw stripped out, the parts to fix it are in the parts lot but I do not have time to fix it myself. Servos shown in pic not included. I do have the clutch, body and radio box and everything for it in case you were wondering.
I want to get $240 shipped for all of it.
I want to get $240 shipped for all of it.
Last edited by BIG RE; 04-12-2010 at 10:24 PM.
#7
If you have working engine that you could include I would give you $220 for it.