2x Futaba R603FS, JR z9100T, and Hobbico cs-140
03-15-2010, 11:22 PM
#1
2x Futaba R603FS, JR z9100T, and Hobbico cs-140
0x (both sold) Futaba R603FS receivers. Antennas are unmolested and they both work beautifully.
^ sold ^
^ sold ^
$65ea shipped insured
Sold JR z9100T ultra high-torque digital servo. Some of the anodizing has worn off on the casing and the wire got a little squished. Probably put a bit of heat-shrink on there and never worry about it again. (In fact, I'll even do it for you, if you want). Works wonderfully, incredibly strong.
Sold
$60 shipped insured
Hobbico cs-140 digital high-speed servo. Was serving throttle / brake duties in my MGT. A great low-cost servo for that role. Works great.
$20 shipped
All shipping offers restricted to the contiguous 48 states. Paypal only.
^ sold ^
^ sold ^
$65ea shipped insured
Sold JR z9100T ultra high-torque digital servo. Some of the anodizing has worn off on the casing and the wire got a little squished. Probably put a bit of heat-shrink on there and never worry about it again. (In fact, I'll even do it for you, if you want). Works wonderfully, incredibly strong.
Code:
Specifications: Type: Ultra High-Torque Digital Servo Torque: 300 oz/in @ 4.8V, 370 oz/in @ 6V Speed: .18 sec / 60 degrees @ 4.8V, .15 sec / 60 degrees @ 6V Dimensions: 0.83" x 1.59" x 1.57" Weight: 2.3 oz Gears: Metal Gears
Sold
$60 shipped insured
Hobbico cs-140 digital high-speed servo. Was serving throttle / brake duties in my MGT. A great low-cost servo for that role. Works great.
Code:
Specifications: Speed: 4.8V = .18 sec @ 60° 6V = .13 sec @ 60° Torque: 4.7V = 65.5 oz-in (4.71kg/cm), 6V = 82.9 oz-in (5.96 kg/cm) Length: 1.58" (40.1mm) Width: .77" (19.5mm) Height: 1.49" (37.9mm) Weight: 1.88oz (53.3g) Lead Length: 10" (254mm)
$20 shipped
All shipping offers restricted to the contiguous 48 states. Paypal only.
Last edited by kuffs; 03-16-2010 at 09:01 AM. Reason: z9100t sold
03-15-2010, 11:35 PM
#3
ygpm
03-15-2010, 11:56 PM
#5
payment sent
03-16-2010, 08:52 AM
#10
I'll take the 9100T. send me PP address
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
