OFNA 10246 SS LiPo/LED 1:8 Starter Box $75
#1
OFNA 10246 SS LiPo/LED 1:8 Starter Box $75
Also fits 1:10 cars. Like new with almost no wear on starter wheel and rubber feet. 11.1V LiPo, LED LiPo warning and power on indicator that changes color if battery voltage drops too low.
Buy this weekend and I'll throw in an good working Integy laser tweak station.
This will start a tight .21 all weekend long no problem. Tons of power unlike non-LiPo powered starter boxes.
Set up for Motonica P8.0R with carbon rear plate. May require drilling/adjustments to fit other chassis.
Buy this weekend and I'll throw in an good working Integy laser tweak station.
This will start a tight .21 all weekend long no problem. Tons of power unlike non-LiPo powered starter boxes.
Set up for Motonica P8.0R with carbon rear plate. May require drilling/adjustments to fit other chassis.
Last edited by ESWLFSE; 04-11-2009 at 10:41 AM.
#2
Starter boxes run on 12.6V gel cel's and or 2 stick packs at 14.8V......i honestly don't know how you are getting away with running a 3 cell that only tops out at 12.6 and will slowly die from there.....you have ZERO advantage over a 12v Gel cel powered box as it stands...you need 4 cell lipo's for starter boxes.
#3
Starter boxes run on 12.6V gel cel's and or 2 stick packs at 14.8V......i honestly don't know how you are getting away with running a 3 cell that only tops out at 12.6 and will slowly die from there.....you have ZERO advantage over a 12v Gel cel powered box as it stands...you need 4 cell lipo's for starter boxes.
TTT for the rest of you with three-digit IQs and that know the difference between the available power and discharge curves of a LiPo vs. a gel, NiCd, or NiMh battery.
#4
ok there buddy.....you keep thinkin your 3 cell is what your supposed to run in a starter box.
#6
name calling....very mature.
#7
Tech Master
iTrader: (47)
To start off with, I have two questions.
How much for the starterbox?
Does this starterbox have a wheel slot at the back of
the box, so it can be configured to start a NTC3?
I would also like to add that I just rewired a starter
box for a guy using a relay and a big amperaged
11.1 lipo battery and it works just fine.
How much for the starterbox?
Does this starterbox have a wheel slot at the back of
the box, so it can be configured to start a NTC3?
I would also like to add that I just rewired a starter
box for a guy using a relay and a big amperaged
11.1 lipo battery and it works just fine.
#8
Here is some more info on it:
Link
I am not familiar with the NTC3. I have also not added a relay and it works fine. The battery only takes a few hundred mA after a whole weekend of effortlessly starting a fresh .21.
Price is $75 shipped OBO.
Box was $65, battery $40, LiPo monitor $25. Battery/box has Dean's connector.
Link
I am not familiar with the NTC3. I have also not added a relay and it works fine. The battery only takes a few hundred mA after a whole weekend of effortlessly starting a fresh .21.
Price is $75 shipped OBO.
Box was $65, battery $40, LiPo monitor $25. Battery/box has Dean's connector.