Factory Team B3
#1
Factory Team B3
Hi I have a have a sweet Factory Team B3 it is all graphite, with a blue aluminum battery bar, the teflon shocks with titanium gold shock shafts, it has the whole complete shock spring set, it has all the blue screws, titanium turnbuckels, with rpm blue ball cups, it has 4 sets of front 3 ribs, and 4 sets of rear tires 2 sets are hole shots and the other 2 are square fuzzies, it has silver aluminum servo saver top deck, tons of extra parts, a custom painted flame body, I have pics, thanks alot. Will trade for a M8 reciver and a nice digital servo doesnt matter what brand servo, the reciver can be anything that works with the M8 like XXL or the stock one that comes with it or anything that works good or NEW.
#2
Tech Apprentice
#3
You got mail.
#4
TTT make me some offers guys.
#5
Will trade for a nitro motor.
#7
I have a very nicely treated, low hours XTM .15 with a slide carb, and pull start that is being neglected on my workbench? Has sat the last few months with after-run oil in it, airfilter on the carb, and a piston locker holding everything at bottom dead center. It has a ported Ofna header bolted to it and Wolfpack Radicals heatsink motor mounts attached ($35 mounts)
Engine is rated to 0.9hp @ 39k rpm, not a barn buner but it has a ton of low-mid end power, ran great at my local small'ish road course in a nitro rs4 2 with 2speed, I sold the car and the engine has sat since, maybe 1/2 gallon through it, was tuned to 210`F and was very strong and consistant.
Engine is rated to 0.9hp @ 39k rpm, not a barn buner but it has a ton of low-mid end power, ran great at my local small'ish road course in a nitro rs4 2 with 2speed, I sold the car and the engine has sat since, maybe 1/2 gallon through it, was tuned to 210`F and was very strong and consistant.
#8
#9
Tech Adept
I'm interested in the B3 and I think I have a nib .12 SG engine at home ... problem is I just moved and it'll take some schlupping around to find it. If I can find it, it's the Yokomo 12 that came with the GT, slide carb, nice porting on the sleeve ... I got it to put in my Ofna OB4 pro but couldn't figure out how to get an SG shaft to work in it so it's just been sitting. Non pull start. I'll look for it tonight when I get home from work. -John
#10
TTT make me some offers guys
#11
TTT
#12
#13
TTT
Last edited by TexasRacer; 12-12-2003 at 04:13 AM.
#14
The car is super sweet and very smooth looking for trades.
Last edited by TexasRacer; 12-12-2003 at 04:14 AM.
#15
pic 1