Well here it is, make offers.
i will be listing prices for everything within the next couple of days.
Thanks
Am Also Interested In Trading For a FAAST Radio Set Up
Let Me Know What You Have.
COMPLETELY PARTING THIS TRUCK OUT
http://search.ebay.com/_W0QQsassZride_wake_210
Parts Currently Installed-
BRAND NEW PARTS-
Tekno receiver box, modded, $7
Traxxas hard anodized shocks, $50
Orange and green springs, $3 each
Himoto V2 wing, $9
CRT .5 header and pipe, $30
RC Screws Stainless screw kit/ majority are polished- $15
Dynamite counter sunk washer/ blue and silver-$2
Front body posts and mount, $3
Proline steering arm, $8
Team Losi Pipe hanger mount, $2
3racing engine mount(part that attaches to engine), $9
RD Racing blue aluminum rear shock mount, $10
ProTek rc wheel bearings all around,
SOLD
Qoncepts chassis brace, $13
Center shafts, $2
Traxxas aluminum pillow balls, $18
rear pivot ball dust boots. $3
Custom rear body post mount brace, FREE
USED PARTS INSTALLED-
Flywheel and clutch set up, $14
OS .18TM with less then 1 gallon converted to bump start, $100
Front shock mount, $1
Front bumper mount, $1
Hobao hyper 8 bumper,modded, $2
Rear body posts and mount, $3
Racers edge 14t clutch bell, $6
Spektrum DX 3.0 with brand new antenna, $100
Extra Parts I Have-
NIP lunsford titanium hinge pins, $20
NIP wide ratio gear set, $5
NIP traxxas chassis brace, $5
NIP shock rebuild kit(3 packs), $3.50 each
NIP FOC, $9
NIP front and rear skid plates, $5
NIP servo saver mount and steering arm stop, $2
used center skid, $1
used 2 rear upper arms, $3
used 1 rear lower arm, $1
used 1 front upper arm, $1
New front bulk heads, $12
used lot of stock hinge pins, push rods and turnbuckles, $8
LOTS of brand new AvidProTek and Stock Bearings, $45
used tan and gold springs, $5 for all 4
spare rockers, $2
New front skid plate set, $2
2 traxxas 1100 mah flat receiver packs, 1 new 1 used, $12 each
Brand New 40t spur gear, $2
Clutch Bells,
2 1/8 clutcheblls- 1 18t and 1 15t, Both BRAND NEW, $7 each
3 Traxxas clutchbells, 1 20t, 1 18t, and 1 14t, ALL BRAND NEW, $7 each
USED Racers Edge 19t, NEW Racers edge 14t, $5 used, $7 new
New slipper rebuild kit, $5
used slipper parts, $2
used/new exhaust couplers/ deflectors, $5
lots of axle pins/ wheel nuts/ 14mm hexes, $6
LOTS of shock parts, retainers/caps, pillow balls,rocker posts, $15
2 outer drive shafts, $7
1 Stock OWB, 4 HPI OWB's, 2 BRAND NEW HPI OWB's, Contact Me
Ching Chang Japan New OS .18Tm sleeve resizer/pincher with instructions, $15
CRT .5 pipe and header, $30
HEAVILY polished, very shiny stock pipe, $10
CRT .5 header, $11
USED THS maxx pipe, ran this on my revo for MANY gallons, it is very beat up $7
2 OS .18TM's, both brand new, $150 each
Sirio .18TX brand new, $110
Brand new Proline bowties mounted on Losi yellow 17mm dish wheels with offset, Ofna orange molded foams(all brand new). $55
Brand new Proline Crime Fighter MTRs with MTR foams mounted on yellow 17mm full offset wheels(all brand new), $55
Brand new Proline Crime Fighter MTRs with MTR foams mounted on white Losi 17mm dish wheels with off set(all brand new), $55
Brand new Proline Hole Shot MTRs with MTR foams mounted on Losi white 17mm dish wheels with off set (all brand new), $55
Parts SOLD-
Vantage 3.3 Chassis
SOLD
Tekno throttle linkage set up/ modded
SOLD
Traxxas sway bars
SOLD
Traxxas wing mount,
SOLD
Golden Horizons blue and silver aluminum shock ends,
SOLD
Traxxas Heavy Duty servo saver spring,
SOLD
Extreme racing carbon fiber brake disc,
SOLD
Extreme racing rear tie bar
SOLD
Custom battery mount
SOLD
Custom tank mount
SOLD
Wide Ratio gears,
SOLD
3.3 transmission with FOC,
SOLD
Traxxas chassis brace
SOLD
Custom carbon fiber wing mount tie bar,
SOLD
AMB Transponder missing 1 mounting tab
SOLD
Brake linkages,
SOLD
Slipper clutch,
SOLD
Center Diff,
SOLD
Rear brake,
SOLD
OuterWears green pre filter for air filter,
SOLD
MS air filter,
SOLD
Spektrum SR3000 receiver,
SOLD
Spektrum SR3000 receiver,
SOLD
few axle yokes,
SOLD
couple stub axles,
SOLD
Used Proline Crime fighter MTRs
SOLD
Resonator dual chamber pipe,
SOLD
Tango Body, unmounted, brand new paint.
SOLD
Tekno throttle mount
SOLD
Associated factory team NTC3 starter box with Native Racing Conversion for REVO,
SOLD
5 axle carriers, some new,
SOLD
38t spur gear,
SOLD
HPI Roto Start, [b]SOLD[/B
Vantage V-Armor in silver,
SOLD
Shock oils/ diff fluids [b]SOLD[/B
NIP maximizer composite 17mm hexes,
SOLD
Losi 8T tank,
SOLD
1 used set of maximizer 17mm composite hexes,
SOLD
Pivot balls,
SOLD
RD logics turnbuckles,
SOLD
Lunsford p2 titanium push rods,
SOLD
P2 rockers dyed black,
SOLD
Diffs front and rear,
SOLD
Front bulk heads,
SOLD
Rear bulk heads,
SOLD
1 new drive shaft,
SOLD
Lunsford Titanium hinge pins,
SOLD
Brand New Jconcepts Tango body, Custom painted,
SOLD
Front traxxas arms,
SOLD
Rear RPM arms,
SOLD
Axle carriers,
SOLD
3 drive shafts,
SOLD
Front and rear skid plates,
SOLD
Front bulkhead aluminum tie bar.
SOLD
Blue Groove Concepts 17mm 241 super wides with Panther tires,
SOLD
Blue Groove Concepts 17mm hubs,
SOLD
There may be a few parts i have looked over and missed, including extra parts and or parts installed.
The truck is pretty much brand new, it has the slayden steering mods done. Truck weighs 8lb 12oz
the way it sits right now. The tekno receiver box was had one of the tabs that hold the top on trimmed off
so that it will fit where it is currently at. The tekno throttle set up has been modded so the bellcrank is more
straight on with the carb, Front and rear body posts have been trimmed, Roll bar has been trimmed and
lowered. Truck has never seen dirt. It has seen dust and shavings from drilling this and that.
Chassis only has 2 extra holes drilled in it which was a must in order to run the Qoncepts chassis brace.
Everything has been done right, Diffs are 30-500-50, Shocks have 45wt and 50wt shock fluid i belive.
Shocks were built correctly and have been bled correctly. All of the bearings are brand new, The 3.3
transmission has never had a running engine ran on it. It is brand new. The TM installed has been modded
so that a starter box is able to be ran with this set up. Battery mount was made out of 1/16 x 1/2" alumimum.
It is very Sturdy, Still low CG also. the Panther tires have 80% tread left.
ah well there it all is, well thats all of as far as i can tell.
im open for offers on anything for right now.
If i dont get enough offers on the truck as it is now, i will be parting it out.
I've got ALOT of money into what i've got listed above. Im not getting out of r/c
im just taking a brake from Monster trucks and racing for awile.
I have interests in r/c boating, im going to be picking up 2 maybe 3 boats here soon.
Many of you have seen pictures of my revo.
i will be taking pictures of everything together that is listed above soon.
PM me or reply here if you are interested in something.
NEW PICTURES
Thanks!
-Z
Big R/C Sell Out! Revo, lots of parts, Take a look
Similar Threads