Ofna 1/8 Hyper 7 TQ Sport Kit (FREE SHIPPING)
#1
Ofna 1/8 Hyper 7 TQ Sport Kit (FREE SHIPPING)
NEW IN THE BOX HYPER 7 TQ SPORT KIT.
FEATURES: Chassis: 3.2mm Aluminum with countersunk holes
Drive: Four Wheel Drive
Aluminum: Shock towers, bellcrank plate, radio plate, brake plate,
fuel filter, suspension arm plates
Drive Type: Shaft driven, front CV drives
Exhaust: Tuned pipe w/header
Fuel Tank: 4.2oz (125cc) flip top cap with pressure tap in cap and
filter
Sway Bar: Rear sway bar
Clutch: 3-shoe clutch
Transmission: Single-speed
Ball Bearings: Full set installed
Shocks: 4 oil-filled aluminum shocks w/coil-over springs and
shaft boots
Main Gear: 47 tooth
Gearbox: Sealed front, rear, and center differentials
Differentials: Planetary geared
Brakes: Dual disk with splash guard
Tires: 3.2" standard 1/8 buggy sized waffle treaded design w/foams
Wheels: 1-piece slanted 5-Spoke
Body: Clear 1/8 scale buggy body
Bumpers: Front plastic
Suspension: Front and rear double wishbone
Camber Tie Rods: Adjustable if removed in front/adjustable in rear
Steering Tie Rods: Adjustable
Steering: Bell-crank
Servo Saver: Built-in
REQUIRES: Engine: .21 Engine w/Rear Exhaust and Pilot Shaft.
Radio: 2-channel with two standard size servos
Building and track equipment
I CAN HELP U OUT WITH A MOTOR AND OTHER STHFF LIKE THAT.JUST TELL ME WHAT U NEED WITH IT. HIT ME UP AT [email protected]
FEATURES: Chassis: 3.2mm Aluminum with countersunk holes
Drive: Four Wheel Drive
Aluminum: Shock towers, bellcrank plate, radio plate, brake plate,
fuel filter, suspension arm plates
Drive Type: Shaft driven, front CV drives
Exhaust: Tuned pipe w/header
Fuel Tank: 4.2oz (125cc) flip top cap with pressure tap in cap and
filter
Sway Bar: Rear sway bar
Clutch: 3-shoe clutch
Transmission: Single-speed
Ball Bearings: Full set installed
Shocks: 4 oil-filled aluminum shocks w/coil-over springs and
shaft boots
Main Gear: 47 tooth
Gearbox: Sealed front, rear, and center differentials
Differentials: Planetary geared
Brakes: Dual disk with splash guard
Tires: 3.2" standard 1/8 buggy sized waffle treaded design w/foams
Wheels: 1-piece slanted 5-Spoke
Body: Clear 1/8 scale buggy body
Bumpers: Front plastic
Suspension: Front and rear double wishbone
Camber Tie Rods: Adjustable if removed in front/adjustable in rear
Steering Tie Rods: Adjustable
Steering: Bell-crank
Servo Saver: Built-in
REQUIRES: Engine: .21 Engine w/Rear Exhaust and Pilot Shaft.
Radio: 2-channel with two standard size servos
Building and track equipment
I CAN HELP U OUT WITH A MOTOR AND OTHER STHFF LIKE THAT.JUST TELL ME WHAT U NEED WITH IT. HIT ME UP AT [email protected]
#3
price
$235