Race Ready Revo w/OS 18tz
#1
Race Ready Revo w/OS 18tz
Some of you may remember this truck from last year. It's been sitting all winter and is still in almost new condition.
I built this Revo using only the parts that I felt were needed to race. Also used Slayden's setup tips for increased steering and shaving weight. I've raced it 4 qualifiers and one main and that's it. Truck handles great and the TZ motor is a beast! Motor has about 1/2 gallon, including breakin, through it. This is the Slide carb TZ motor and I put the 18TM IPS Revo crank in it so the stock revo clutch lines up perfectly. Here's the breakdown:
Revo 3.3 Chassis (2.5 chassis too)
OS18TZ Turbo w/slide carb w/TM IPS Crankshaft (pilot shaft also included)
Traxxas 40MM Flywheel
Forward Only Conv
Close Ratio Trans
Red Tubes Ft & Rr
Ext Wheelbase Rear Arms
HD Steering Spring
P2 Rocker Arms
Green front springs
Tan rear springs
Dace Wheel adapters
Panther Python tires
Wabash 40 series Wheels (narrowed)
Racers Edge Inserts
JConcepts Body
Hot Bodies Wing Mount
Kyosho Wing
Associated/NativeRacing Starter Box
Misc parts left over from the build (Rr arms, springs, rockers, etc)
Over $900 to build this, I'm asking $500 shipped. I accept Paypal and MO's. E-mail me at [email protected]
Thanks,
Mark
I built this Revo using only the parts that I felt were needed to race. Also used Slayden's setup tips for increased steering and shaving weight. I've raced it 4 qualifiers and one main and that's it. Truck handles great and the TZ motor is a beast! Motor has about 1/2 gallon, including breakin, through it. This is the Slide carb TZ motor and I put the 18TM IPS Revo crank in it so the stock revo clutch lines up perfectly. Here's the breakdown:
Revo 3.3 Chassis (2.5 chassis too)
OS18TZ Turbo w/slide carb w/TM IPS Crankshaft (pilot shaft also included)
Traxxas 40MM Flywheel
Forward Only Conv
Close Ratio Trans
Red Tubes Ft & Rr
Ext Wheelbase Rear Arms
HD Steering Spring
P2 Rocker Arms
Green front springs
Tan rear springs
Dace Wheel adapters
Panther Python tires
Wabash 40 series Wheels (narrowed)
Racers Edge Inserts
JConcepts Body
Hot Bodies Wing Mount
Kyosho Wing
Associated/NativeRacing Starter Box
Misc parts left over from the build (Rr arms, springs, rockers, etc)
Over $900 to build this, I'm asking $500 shipped. I accept Paypal and MO's. E-mail me at [email protected]
Thanks,
Mark
Last edited by Zapped; 07-14-2016 at 07:14 AM.
#3
check your PM'S
#5
another 1
#7
willing to trade?