Flexisign Questions
#1
Flexisign Questions
Got a really lame newbie question.
I have a set of flames that I want to cut out, but I can't figure out how to cut them so they are not outlined. If I cut them as-is the cutter cuts on both sides of the line.
Hope that makes sense.
EDIT: BTW I'm using FlexiSign 8.1
I have a set of flames that I want to cut out, but I can't figure out how to cut them so they are not outlined. If I cut them as-is the cutter cuts on both sides of the line.
Hope that makes sense.
EDIT: BTW I'm using FlexiSign 8.1
#2
uncompound them or ungroup and get rid of ouline