RB Engine Thread
#437
Tech Fanatic
iTrader: (12)
Here is his link for that P/S. Call him he will set you straight.
http://www.murnanmodified.com/produc...roducts_id=221
#438
Where can I find a piston/sleeve for a T10rc? I damaged mine changing the rod, I'm really mad about it too
#439
Tech Fanatic
iTrader: (12)
Had a buddy butcher his piston changing the wrist pin and Ray fixed it I was shocked.
What do you have to loose except the price of shipping.
Here is his direct link and his rctech thread, check out how everyone is so happy with his work
http://www.rayaracing.com/orderresize.htm
.
http://www.rctech.net/forum/offroad-...g-tooling.html
.
.
#440
Send it to RayA this guy is incredible with repairs and such.
Had a buddy butcher his piston changing the wrist pin and Ray fixed it I was shocked.
What do you have to loose except the price of shipping.
Here is his direct link and his rctech thread, check out how everyone is so happy with his work
http://www.rayaracing.com/orderresize.htm
.
http://www.rctech.net/forum/offroad-...g-tooling.html
.
.
Had a buddy butcher his piston changing the wrist pin and Ray fixed it I was shocked.
What do you have to loose except the price of shipping.
Here is his direct link and his rctech thread, check out how everyone is so happy with his work
http://www.rayaracing.com/orderresize.htm
.
http://www.rctech.net/forum/offroad-...g-tooling.html
.
.
I'd have this motor for Kissimmee as a back up. I'm really happy I went with RB this season, great reliable motors
#441
Rodey V-12 (5 Port)
just bought a NIB 5 port and cannot wait to break it in and compare it to my
JP Modified NR (5 port). have always ran JP's (.12 &.21) have seen a few .21 rodey's and they were monsters.
JP Modified NR (5 port). have always ran JP's (.12 &.21) have seen a few .21 rodey's and they were monsters.
#445
Tech Elite
iTrader: (32)
Again, I advise to measure them first to be safe. According to their website, their rear is 14.5 and front 7x 19 Z special.. that's all. I think Nova have these sizes, but measure them to be safe.
From what I know, in the past RB was Nova based, till a couple or more years back (not verified). They also kinda lost focus on On-road and do Off-road more. The parts now are different and so hard to get in this part of the world. Nonetheless, they produced good engines.
#448
I did it once:
An 5mm diamond dremel bit did fit tight in the hole and just with 3 counts powered by a Dremel it did fit the RB crankpin.