MT12 problems
#1
Tech Regular
Thread Starter
MT12 problems
can anybody give me a setup on the mt12?
#2
Re: MT12 problems
Originally posted by rc-racer15
can anybody give me a setup on the mt12?
can anybody give me a setup on the mt12?
HSN = 5 turns out, then start leaning 1/8th at a time if needed.
LSN = 3 turns out, then lean or open as needed to get at least 30 seconds idle without engine clogin to the point of dying, it should hesitate a little after 30 seconds but not die. To do this, let engine idle then press full throtle for a second or two to clean it out, then check the 30 seconds idle.
Mid Needle = flush with carb body with slot for screwdriver pointing the fuel inlet, then DON'T EVER TOUCH IT AGAIN.
AFM
#3
What characteristics would an overly lean bottom end give? I'm having some setting issues and I could use some help. Thanks
#4
Originally posted by gonzoY5
What characteristics would an overly lean bottom end give? I'm having some setting issues and I could use some help. Thanks
What characteristics would an overly lean bottom end give? I'm having some setting issues and I could use some help. Thanks
Good Luck
AFM
http://www.teamtrinity.com/tech/nitrotune.asp
http://www.teamtrinity.com/tips/nitro.asp